How do you open hood on 1994 Cutlass Supreme?
There should be a lever between the door and the drivers seat, on the floor
lever along side drivers seat.
How do you open the hood on a 1995 Cutlass Supreme if the hood release wire is not working from within the car and you can see the hood latch under the hood but you can't get the hood up when you try?
This is what I have had to do for my 94 cutlass supreme. Hold the hood release wire lever open from inside the car with a something - a screwdriver or some such thing. Then just pull up on the hood and voila, it releases the latch.
Dealer said necessary to cut segment from guide tube to get to the cable.
on the 1994 CUTLASS SUPREME IT IS ON THE RIGHT SIDE OF THE DASH PANEL OPEN THE DOOR AND LOOK AT THE SIDE OF THE DASH THERE IS A PANEL THERE LABELED FUSES IT IS OBLONG LOOKING THERE YOU GO ALL OTHER ANSWERS ARE NONSENCE LIKE LOOK IN THE MANUAL YEA RIGHT
the 71 cutlass has no cable pull on latch in the middle of grill or just below frt. bumper
how to open hood with a broken cable on a 1994 ford explorer
The fuse panel is underneath the glove box. Open the glove box door and lift out the inside tray.
Fuse block is located behind the glove compartment. Open compartment and pull out entire box and you will see fuse block
when you open the hood there will be a yellowish white tank near the top left hand corner of the engine compartment. this is the coolant tank. there will be markings on the side for the levls the coolant should be at when the engine is hot and when it is cold. make sure the coolant you put in is the same colour as the stuff in the tank
How do you get the hood of a 1992 cutlass siera open when the hood latch cable is all the way back and not broken?
hold out on handle another person tap on frt. of the hood
Could you show me where the cigarette lighter fuse is located on a 1994 Oldsmobile Cutlass Supreme.?
Open the glove box, then lift out the liner. you will then see the fuse panel. The fuse slots are labelled. Hope that helps.
How do you open the hood when the inside hood release is broken on a 1990 Oldsmobile Cutlass Supreme?
On my 1988 Cutlass Supreme the cable broke at the release point in the car. I was unable to see anything from the outside so in the passenger compartment I took the release handle apart and used a set up pliers to pull the cable and release the hood. There should be just on bolt holding the release in place, it may be covered by the carpet. If it can't be done from the inside… Read More
Pull the inner door panel off and look inside the door and you will probably find a rod off the outside door handle.
The ECM fuse is located inside the car. Open the little glove box, and pull out the liner. From there you can see the Fusebox. It is labelled ECM
open the fuse box and there should b a diagram on the underside of the lid.
With the key, there is no trunk release inside the car. You use the same key you would use to open the door to open the trunk.
Throttle plate stuck in open position
driver side left foot area there is a hood leveler, you pull it if it will not open your cable may be damage.
Open the glovebox, pull out the black comparment, look down and you will find the fusebox.
Find someone with a big strong hand. Pull hood release handle. If this does not open hood about one inch to allow opening it then on the front edge of the hood just left of center line rap hard on hood one time with your hand. This usually will cause the hood to pop up that one inch allowing you to open. If this doesn't work the first time try again. If you hit it… Read More
Open the passenger side door, and theres a fuse door there. On the back of the fuse door, it should tell you wich fuse is te lighter fuse. It's probably an accessory fuse.
Open passenger door. Look on the end of the dash panel for a door marked "FUSES".
Open the hood. Facing the engine from the front of the card, look on the left side of the card...near the cooling system overflow bottle. To the right of the area is the drive belt. In the lower area you will see the two hoses for the cooling system fluids that connect to the water pump. The drive belt goes over a pulley that drives the water pump.
How do you get the trunk open on 1993 Oldsmobile Cutlass Supreme LS with factory installed security device and key will not turn lock?
Open the glove box, and there should be a button to pop your trunk
Open up the hood, look straight down and it's close to the bottom of the engine. you can actually see it with no problem.
Hello,I found the problem.I opened it with a crowbar,then I unseized the latch and plenty of penetrating fluid.Thank you
Pull on the hood release handle under the dash driver side. Then go to the front of the car, lift the hood slightly to access the secondary hood catch. Release it and open the hood. Pull on the hood release handle under the dash driver side. Then go to the front of the car, lift the hood slightly to access the secondary hood catch. Release it and open the hood.
its right on the front of the motor...down twords the bottom..open ur eyes ...very obvious
Any suggestions on getting open the doors of a 1992 Olds Cutlass Supreme The handles are NOT broken however neither door will open from inside or out. The locks are fine and unlocked.?
crawl in from the trunk i do
The initial hood release is in the glovebox. just pull it and the hood will pop-up an inch or two. You'll find a secondry release under the hood. Sometimes the first attempt to open the hood fails. You may have to "play with it" for awhile!
OPEN THE GLOVE BOX. YOU WILL SEE A SMALL DOOR TO THE Left. that's the hiding place of the fuses..
How do you open the hood when the cable brakes on a 1997 Oldsmobile cutlass supreme. the cable broke loose at the latch?
i had the same problem. the hood release is controlled by a cable. what i had to do was take off the cover by the driver side seat,grab the cable with a pair of vise gripps and pull the wire in the cable with a pair of pliers. it sounds crude but that's the only way to get the hood up. by the way,i would take it somewhere to get the cable replaced.it's buried!!!!!
Pull the hood release lever near the parking brake on the bottom of the driver's side dash. Push the lever under the hood up and push up on the hood.
Hood stuck on 1994 ford explorer how do you open it you let it close and it stuck part up you can't open by pulling release or hitting the hood?
Reach through the plastic grill and pull cable!!!!!!
There should be a sticker under the hood right around the lever to open it, the sticker shows you the correct way.
if your latch just broke, use a vice grip. if the cable itself has snapped, it gets tricker. my 2nd cutlass's cable snapped. i had to lift and jerk the hood manually until it came loose.
open hood look to ur left on firewall.
open your glove box. its under the lid..remove the whole box unit by lifting it up and out. the fuses are under there
Not sure but you should look up the safety recall on this car because it had a hood latch recall.
Ground the factory hood pin so that the vehicle thinks the hood is open, it will never arm again.
I had the same problem had someone push down hard on the front hood while I pulled the inside hood release then put wd 40 lubricant.
Interesting question. Never heard of a diver's side. Please explain so I can render an informed answer.
TAke it to the body shop as they have to do it when a car is wrecked.
http://www.kick-fix.com/find-parts.html on the hood is a vacuum diagram. required by law. open hood. look up .under hood ,not down.
what can I do ican,t open my hood
Open the glove box, which should be opened by turning the round lock. Then, take everything out of the glove box. Now, pull the "Box" itself out. The fuses are located here. ANSWER On my 95 cutlass supreme, the fuse box is on the side of the dash, right inside the passenger side door. You have to remove a panel that says "fuses" on it.
It is hidden in the dash on a the passengers side. To locate it u must open the front passengers door.
there should be enough of a gap to stick a flat head screwdriver between the hood and the grill. the level sticks out just enough that you can push it. the interior latch has a cable with a metal bead at the end that connects to a metal loop. that is the release for the hood latch. push it, and then use the safety release to open the hood.
It's right in front and center. It has a yellow circular handle, and is just to the right and slightly in front of the oil cap when you open the hood.
TO CHANGE A LOW BEAM HEADLIGHT YOU FIRST OPEN THE HOOD THERE SHOULD BE THREE PLASTIC GROMETS WITH A REMOVEBLE CENTERD. REMOVE THESE CENTERS AND THE PLASTIC PIECE WILL LIFT OFF. THEN THERE ARE TWO TORX SCREWS THAT HOLD THE HEADLIGHT RING IN PLACE THE OTHER SIDE IS HINGED AND WILL SWING OUT OF THE WAY. YOU MAY HAVE TO USE A SOCKET FOR THIS .