Chevy Cavalier

How do you open the hood of 1992 Chevy Cavalier when the cable is broken?

91011

Top Answer
User Avatar
Wiki User
Answered
2008-10-21 14:57:02
2008-10-21 14:57:02

Stick a long screwdriver between the hood and the the small trim piece in the front middle of vehicle and try to locate the small latch that the cable would pull if it was there. It will take some force but push it to the right when facing the front of the vehicle. After this disengages then you should be able to open your hood with the finger latch. A flashlight helps.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


i would like to remove the backseat from my 1992 chevy cavalier

how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder

The directional flasher for a 1992 Chevy Cavalier is under the dash. It is mounted on the drivers side, beside of the steering column.

Do you have a picture of location of crankshaft position sensor for 1992 Chevy Cavalier 2.2L ohv engine?

That is referred to as "back dating" and it is illegal at the federal level.

You can check your automatic transmission fluid in your 1992 Chevy Cavalier with the transmission dipstick. The dipstick will have marks that indicate whether it is full or low one quart.

Go to the auto zone for parts and instructions

http://wiki.answers.com/Q/How_do_you_tighten_your_alternator_belt_1992_Chevy_Cavalier"

yes it does and depending on the engine some have more then one

Knowing the firing order of a cars engine can help diagnose car problems. The firing order for a 1992 Chevy Cavalier is 1-2-3-4-5-6.

what adjustment cable if you are talking about clutch adjustment if it is hydraulic there is no adjustment for it per the Chevy dealer i brought my 1992 s 10 to

its located at the rear of the engine (center) attached to the block

try your chev dealer and they should be free

In the center console, below the trap door.

Usually in housing at engine end of upper radiator hose

its on the passerger side by the front wheel under the power steering.

the 3.1 liter v6 and the 4 cylinder both have sepentine belts

from what i have been told that you disconnect the battery terminals and then reconnect them. that should reset the computer

Under car on frame rail near driver seat area.

this question is very simple. Buy a owner manual for your car.

In the gas tank. Costs about 300-500 dollars for a shop to replace it..

under the hood on the passenger side looks like a little grill with a plug or 2 in it !---------------!=! !---------------! !==== !---------------!=! !---------------!=! !---------------! !==== !---------------!=!

It depends which cable is broken. If the main cable is broken under the truck, the brakes should release on their own. If the brakes dont release, the cables are frozen from rust and need to be replaced. If the release cable from the handle to pedal assemdly is broken reach under the dash above the pedal and find the small release arm. Pull the arm toward you [ the rear of vehicle ] and the emergency brake pedal will release.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.