the front of the car is a hole put your hand in find the cable and pull down i have the same car hope this help you highvolt 69@Yahoo.com
dodge truck broken hood latch
Open the hood as far as you can then use a flat-blade screwdriver to pust the latch. Just remember to always carry the tool and a flashlight to locate the latch.
With a pair of pliers pulling the latch.
Need more information. Is the latch behind the grill broken? Or is it the latch operated from inside the vehicle? If it's the latter you can remove the latch mechanism and pull on the cable using pliers or vise grips.
Use a set of pliers to pull the cable even if the plastic latch is broken...
my 2001 does the same thing. its the spring in the latch release. I have to have my wife sit in the car and keep popping the hood release while i push in and up and down on the hood right where the latch release is over and over and eventually it gives. Once you get the hang of it you can do it by yourself.
There is a screwdriver slot behind the grill that will operate the hood latch. Look for it on the driver's side.
There is a screwdriver slot behind the grill that will operate the hood latch. Look for it on the driver's side
You may pull the wire with a pair of plyers near the hood latch. To access it you need to reach behind the grille of the car and pull the exposed wire near the latch with the plyers
in the glovebox
my latch is broken on my Honda and all i did was put a bungy cord thru the loop in the hood and pull it to the tow hitch on the bottom of the car and it works fine
IF the Cable is broken on the hood latch, I used a long, flat head screwdriver. Locate the eyelet under the hood, and push it with the screwdriver. It's difficult, but it works. Replace the hood latch before you close the hood. Good zluck.
Opening the hood on a 2001 Pontiac Grand Am is very easy to do. The hood is opened by pulling on the hood release latch inside the car on the drivers side. After the latch is pulled the hood will release. The hood is then opened by pulling the second release under the hood.
Take the grill out and remove the bolts holding the latch on.
i would probably use a screwdriver to nudge where the latch used to be to pop it open
The only way i can think of would be to remove your bumper so you can get to the latch, and either unbolt the latch from the core support or unbolt it from the hood...
How to open of my BMW 745LI Yr 2003 hood ,whose Hood latch is broken while tried to open the hood
how to get a 2001 isuzu trooper hood open if release cable is broken
you can get to the latch through the grill
Use a screwdriver to release the hood latch through the front grille. Take a look at the hood latch on another car to get an idea of how they work.
To open the hood on a 1993 Pontiac Grand Prix after the cables have worn our by the seat release, have someone hold the lever up. Another person presses down ?æthe hood near the latches. Then clean and lubricate the latch mechanism.?æ?æ?æ
Have 1 person pull on cord with pliers and 2nd person use fist to pound on hood where hood latch is and/or use screwdriver to pry open hood.
If the cable release is broken for the hood on a 2002 Kia Spectra, a person could crawl under the car and see if they can locate the broken part of the cable. If it is still attached to the hood, they could pull it to trip the hood latch. Otherwise, the car will have to be put on a hoist, and a long pole used to trip the hood latch.
The latch is broken or out of adjustment.