answersLogoWhite

0


Best Answer
Copy

Take a flat screw driver and use it to push the spring away from the hood latch. Locate the screw driver at the end of the cable. This works for mine.

User Avatar

Wiki User

โˆ™ 2015-07-15 21:15:01
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you open the hood on a 1986 S10 Blazer when the release cable breaks?
Write your answer...
Submit

Related Questions

What are the release dates for Throb - 1986 The Cable Show 2-16?

Throb - 1986 The Cable Show 2-16 was released on: USA: 13 February 1988


Does a 1986 Chevy s10 blazer have ignition points?

No.


Can you swap the gas tank from a 1986 blazer to a 1987 blazer?

Yes you can. There the same. Just take the parts / sending unit out of the 1987 tank and install them in the 1986 tank.


Does 86 Honda Prelude have clutch cable?

The 1986 Honda Prelude does not have a clutch cable. The 1986 Prelude has a hydraulic clutch instead of the clutch cable.


When did Tommy Cable die?

Tommy Cable died in 1986.


What is the firing order for 1986 k5 blazer 5.7l?

18436572


Did 1986 Chevrolet Blazer come with catalytic converter?

Yes


Is the 1986 Nissian Stanza speedometer cable or machanical?

Cable is mechanical.


What does your 1986 blazer have for a Differential?

That is your rear axle. It delivers the power to your tires.


Where is the tps located on your 1986 k5 blazer 350 mtr 4x4?

You can't find it because they were NOT used in 1986


How do you replace the speedometer cable on a 1986 Chevy Celebrity?

To replace the speedometer cable on a 1986 Chevy Celebrity: According to my factory service manual: 1. Remove the trim panel underneath the steering column. 2. The cable is held in place by a quick release button. Reach up by the steering column and push the quick release button and pull the cable off. I like to attach a wire or string to the cable so that I have something to pull the new cable in with. Then under the hood: 1. Pull the speedometer cable out of the dash, if you used a wire untie it. 2. Follow the cable to the other end at the transaxle. Unscrew the nut that holds the cable to the transaxle, pull the cable out. Reverse these steps to install the new cable. Be careful to follow the route of the original cable.


What is the correct Timing for a 1986 Chevy blazer with a 350?

8 to 10 degrees.


Where is the fuel filter located on a 1986 Chevy Blazer?

On the fuel line going to the carburetor.


How do you change the sending unit on a 1986 Chevy Blazer?

Which sending unit? Oil or temperature? Or ?????


Where is the voltage regulator on an 1986 S10 Blazer?

It is built into the alternator. It is all 1 unit.


What is the towing capacity of a 1986 Chevy Blazer?

go to chuck's Chevy pages .com the answer should be there.


What size are the bolts for the transmission of a 1986 blazer?

The bell housing bolts are 3/8-16.


What is the latest engine that will fit in a 1986 Chevy k5 blazer?

1987 is the last year for a carburetor.


What is the towing capacity of a 1984 Chevy K5 Blazer?

Here's a link to the answers most are looking for. It's a brochure for the 1986 Blazer/Suburban/Jimmy's. Looks like 6000lbs for gasoline engines, less for diesel. http://www.coloradok5.com/brochures/1986/


Why doesn't my 1986 Delta eighty eight royal Brougham speedometer work Is it a sensor or cable?

Probably cable


What is the cause of erratic timing on 1986 S-10 blazer?

worn or loose timing belt?


Where is the map sensor on a 1986 S-10 blazer?

It does not have one, only fuel injected engines have one.


Where is fuel pressure regulator on 1986 s-10 Chevy blazer 2.8 liter?

It is in the throttle body.


What are the release dates for Jane - 1986?

Jane - 1986 was released on: USA: 1986


What are the release dates for Ecstasy - 1986?

Ecstasy - 1986 was released on: USA: 1986