Chevy S-10

How do you operate the security system on a 1999 Chevy S10?


Top Answer
User Avatar
Wiki User
2008-07-16 05:08:12
2008-07-16 05:08:12

if you have a key fob hit the lock button and the doors should lock press it again, the horn should honk , alarm is on. to test it out roll your windows down first then go and lock the doors with the fob and hit lock to set the alarm on, (horn should honk) unlock the door by hand and open door, horn should honk quietly then go off full volume after 30 seconds


Related Questions

the security system for the radio has "locked" my radio. how do i un-do that? i do not have the security/locks pod for the vehicle.

You don't. You douse it with gasoline and throw a match on it.

Be sure to check your security system if you have one. Many of the security systems will "kill" the start circuit when triggered.

1999 Chevy lumina, won't start, security light comes on ,can jump the starter but motor will only run for a short time , strong battery ? tried different keys , no good ? help

If the computer and the security system is not communicating correctly the security light will come on in a 1999 Chevy Suburban. Starting the car with a spare key may offer a quick fix.

1999 chev van 2500 5.0 liter engine run and stop

the 1999 venture has the PK3 system for security, so you have to go to a GM dealer or a automotive locksmith that has the proper box to reset it or make a new master key for it.

It should turn off when the key is turned to the 'on' position.

Traction Control System Traction Control System

You can add Freon to your 1999 Chevy cooling system through the low pressure port. Connect your Freon bottle to the low pressure port and release the Freon into the system.

NO it will not, The computer system on the truck is different.

it has to be reset with a scanner MT 2500

The security system was installed for a reason. There is no reason that it should be bypassed. This forum is not to answer questions that may be illegal or immoral.

1999 Chevy what? What kind of 1999 Chevy. different models have different sensor positions

possible your alternator is going bad, get your charging system checked out.

It is the Security System - Cost just under $600 to repair at the dealer - pretty sure that was a "dealer" inflated price -- but they do it to you every time. Replaced the ingnition and reset the the "BS" security system.

The car won't start because of the security system. The security system will either have to be bypassed (there are kits available on Ebay sometimes and there are some websites that have them too) or replaced. The ignition key has a built in resistor that the security system checks when you try to start the car. If the security system doesn't recognize the resistance of the key it won't start the car. Then you have to wait 2 to 10 minutes before it will start ( sometimes it's a lot longer than 10 minutes). You could try getting a replacement key and see if the security system recognizes it better. GM installed security systems in their vehicles that are called Passkey I, II and III. So if you get a kit you have to know which system is in your vehicle.

Repair the ABS system so it functions.

Yes it will set right in and bolt up but it will NOT run due to the fuel system and COMPUTER system.

No, it is hardwired into the ecm and the rest of the car.

if it is automatic then no because in 1996 Chevy swiched to the (e) electronic trans and would need a different computer system to work.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.