It easy to do use a pitmen arm puller or i just use a big gear puller to pull your pitmen arm or this is the hardest part they are prest on pretty tightly I tighten up the puller and then hit the pitmen arm with a hammer a few times then tighten up the puller over and over again till it comes off you may have to heat it up some if its really on there then there is two lines to disconect and the box should be held in by 3 bolts through the frame rail...that it put the new one back on
how to replace an oil pan that goes to a ford f150 1993? how much does the pan cost,and can you show a picture of it?
Yes.
ford f150 svt raptor
There is no OBDII connector on 1993 F150. Didn't start until 1996 (97 model).
What question
A 2010 Ford F150 pick-up uses automatic transmission fluid.
Steering wheel?
on the top of the differential
On a 2001 Ford F150, the turn signal flasher is located in a relay box on the passenger's side of the steering column. To access it, you must remove the panel under the steering column.
IT IS ATTACHED TO THE PUMP AT THE FRONT OF THE ENGINE
Yes it will
i cannot get the brake lights to work