Have all of the available remotes in hand, put key into ignition and cycle key 8 times rapidly, ending in the on position (on & off = 1 cycle, do not engage starter), door locks will cycle, letting you know that the vehicle is in program mode. To program remote, push the unlock button on each clicker, to close programming, turn car off.
the batterys in your keyless remote may need to be changed
Keyless entry will have a keypad built into the driver's door handle.
Your Sable will have keyless entry if there is a numbered access keypad mounted under the driver's door handle on the outside of the door. Your owners manual will have the default code for using the keypad and will also have instructions on how to program a personal code.
it depends on what year for the sable. if you have the owners manual it should say.... if it is a newer model you put the key in and turn it on to off 5 times the hit all the buttons on your remote that should program it
Each vehicle with keyless entry has its own factory code
Remotes for automobiles can stop working for a variety of reasons. First check the battery, then reprogram if this is not the answer. Check with a mercury dealership to have the remote evaluated.
It is printed on the computer which is normally under the kick panel or mounted against the rear seat in the trunk.
Mercury Sable was created in 1986.
mercury sable
If you have the driver-side keypad and know your code, just enter your code and then press 5.
where is the solenoid on a 2004 mercury sable
how do I remove my air bag from my mercury sable