In order to take the dashboard apart on a 2006 F150 you will have to remove between the six clips that are holding it in place. Open the ashtray and begin to gently pull the dashboard away, remove the clips as it begins to come off. You should not have to pull hard or force it.
The sensor is located under the oval shaped panel on top of your dashboard. Should pull right up and you will see the sensor attached to the bottom of this panel.
pull the hood latch and by the grill to the left of the ford logo there is a handle push it left and there it is
There is a button at the base of one of the supports, push it and pull up.
under the dashboard if you pull a lever out it pops down
pull them off and put new ones on...problem solved
under the dash on the driver side pillar a behind the hood pull
pull down the tailgate and the screws to take off the tail light cover. pull that off and it is the bottom bulb
Pull the blown one out, push the new one of same amp rating back in.
Bottom left side of the drivers side dashboard. The pull handle is molded to look like its part of the lower lip of the dashboard.
The min thickness should be stamped on the backside of the rotor, pull and examine.
Front or back. Pull it apart and check.
lower the tailgate, remove the 2 screws on the side when you lower the tailgate, pull assembly out and replace
Use a freaking spanner and wrench dude XD Jesus man that is the funniest question i have seen in ages.
pull really hard
Pull the fuse.
The 1994 Ford Thunderbird motor mounts are secured with a bolt and nut running through the middle of the motor mount. Loosen the nut and pull the bolt out.
The back seat on a Ford F150 FX4 can be removed by locating the straps in the back part of the seat. Pull up on the straps to remove the seat.
I had this problem before on a ranger you have to pull the dash board out and it will be right there.
You pull it
You'll need to pull the big nut in the middle, then use a wheel puller or balancer puller.
At www.autozone.com. Sign up as a member and add your vehicle and you should be able to pull up a manual.
Computer controlled If you have a 3.0 you can turn the distributor to adjust, after you pull out the adjustment chip.
Below and to the left of the steering wheel, it is a pull out style knob.
you have to pull the entire speedometer cluster on the back of it you will see little lights turn them until they come out and replace them with new ones