use a large c clamp and push the piston back in, just be sure to not over fill you master brake cylinder because you will be pushing more fluid into it.
The teves caliper is a single piston disc brake caliper and the akebono caliper is a dual piston disc brake caliper. The teves caliper is a single piston disc brake caliper and the akebono caliper is a dual piston disc brake caliper.
If it is the front brake use a "C" clamp to retract piston If it is the rear and the parking brake is used by this caliper piston is threaded and a special tool (not expensive) available at Sears or auto parts to "screw" piston into caliper body
If you can't compress the piston with a C clamp back in to position to fit the new brake pads I would suggest replacing the caliper completely.
Hydraulic force, transmitted by the brake fluid.
You can use a large C-Clamp to compress the caliper piston.
The piston is forced out of the caliper by the pressure of the brake fluid. This pushes the brake pads against the rotor, in turn stopping the vehicle.
Remove caliper mounting bolts Slide caliper off rotor Use a "C" clamp to fully retract piston into caliper body If parking brake is used on this caliper piston is threaded and a special tool (not expensive) is required to thread piston into caliper body
Yes, there is such a thing as twin-piston calipers.
You probably have frozen brake caliper slider pins or a frozen brake caliper piston on one side.
Remove wheels Loosen 2 caliper mounting bolts and remove Remove Rotor (if peel off type) Resecure caliper Remove brake pads Need to get special tool to retract piston into caliper Do not retract using "C" clamp these pistons have to screw back into calpier (Clockwise) After piston retracted totally install new brake pads and reverse procedure to install DO NOT MOVE VEHICLE UNTIL BRAKE IS PUMPED TO RESET PADS TO CALIPER
this can be calculated by measurements of the bore
Clockwise to retract piston into caliper body