answersLogoWhite
Chevy Malibu

How do you put a license plate holder on a 2004 Chevy Malibu?

363738

Top Answer
User Avatar
Wiki User
2015-07-15 21:34:51
2015-07-15 21:34:51

take off the license plate then screw the holder on with the plate.

1

Related Questions

User Avatar

yes there is, just above rear plate.

User Avatar

Yes, by law all rear plates must be lighted.

User Avatar

A Chevy Tahoe's license plate bulb can be used to light up the license plate. In the dark the license's plate will still be visible.

User Avatar

in back above liscense plate,there should be 2 screws undo these screws, and pull out assembly to change bulb.

User Avatar

You can order personalized license plate holders through autoplate.com or through amazon.com. They average $15-22.

User Avatar

The easiest way i figured out was take the plate off the lights are vertically installed so open the trunk and remove the license plate. See sources and related links below for license plate bulb information.

User Avatar

Yes, all cars have a license plate light. It is mandated by law.

User Avatar

Go to the dealership and purchase a license plate holder. There should be instructions as to the installation. You will need to drill 3 holes,denoted by dimples, in the bumper. Install the holder and then your tag.

User Avatar

· lugnuts · light bulbs · license plate holder

User Avatar

remove the bulb holder from behind the lense (inside the bumper) with a 1/4 turn. replace the bulb and reverse for reinstalation.

User Avatar

Somewhereit is on side of throttle body, at the throttle plate.

User Avatar

I recently purchased a new 2009 Malibu. Because it appeared that a special tool is needed to unscrew the three fasteners, I requested the dealer to have their bodyshop remove the license plate bracket. The bodyshop apparently had to drill the fasteners out.

User Avatar

how to change 2005 equinox license plate light i removed the screws but it didn't release

User Avatar

unscrew the bulb in the opening above the rear license plate holder- bring the bulb to an auto parts dealer then replace the bulb

User Avatar

as far as i know ,there is no fuse, it works off lighting curcuit.

User Avatar

lug nutslicense plate holderlight bulbs

User Avatar

To change the license plate light on a 1998 Chevy Cavalier, reach up under the bumper and remove the bulb over the license plate. Then put a new bulb in the socket. The bulb can also be accessed by removing the lens on the outside, but there are screws to remove first.

User Avatar

Behind the rear license plate housing

User Avatar

Right above the front license plate.

User Avatar

You can replace the license plate light on a 2001 Lincoln Is by carefully prying the bulb holder and turning the light counterclockwise while pressing down on it. The bulb will loosen and then can be taken out. A new bulb can be screwed into the bulb holder by turning it clockwise.

User Avatar

the sensor is black an it is on the side of the throttle body at throttle plate!!

User Avatar

Remove License Plate, rotate bulb holder counterclockwise & pull out, remove bulb by pulling straight out, install new bulb (#194), check if it lights, reinstall...

User Avatar

Drain the fuel from your 2000 Chevy Malibu fuel tank. Remove the fuel line. Remove the fuel filter retaining plate. Reverse the process to install the new fuel filter.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.