Ford Explorer
Ford Ranger
Ford Explorer XLS
Ford Explorer XLT

How do you put a new IAC valve on a 2000 Ford Explorer?

121314

Top Answer
User Avatar
Wiki User
Answered
2005-10-28 19:40:11
2005-10-28 19:40:11

Piece of cake. Takes all of 5 minutes to do. This pertains to a '98 but I doubt it will be much different with an '00. Take the large plastice cover off the top of the engine. (4 hex screws need to be removed.) Unplug the IAC valve. If you have the new part or know what to look for you can't miss it. It's right there. Unscrew the 2 IAC valve screws. Wipe down the gasket with a clean rag. Put the new one on. Put the screws back. Voila!! Done.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Driver side of upper intake manifold. Just behind the IAC valve. IAC is just behind the throttle body.

If you look at the engine , from the drivers side of your Explorer , the IAC valve is mounted on the side of the upper " plastic " intake manifold close to the 4.0 L EFI raised lettering on the manifold . It is mounted just above the rectangular shaped DPFE sensor

IAC sits on the top of the motor.

The IAC valve is mounted on the upper intake plenum (manifold)

The IAC is located on the throttle body. Simply unplug the dirty IAC and clean or replace the IAC.

iac valve...idle air control valve

On most models, the Idle Air Control (IAC) valve is located on the throttle body.

According to my Chilton repair manual : P1504 - idle air control (IAC) valve and / or circuit fault

Try replacing you IAC valve. And cleaning tha Mass Air Flow Sensor

Its on the back of the throttle body.

The idle air control (IAC) valve on my 4.0 L OHV is on the driver's side of the engine mounted on the side of the upper "plastic" intake manifold. Removing the valve and CLEANING it does wonders for its operation ability.

no have , per wiring diagram.There is no IAC motor for this engine and I suspect you have an error code

It's under the throttle body. To get to it, you'll need to remove the throttle body and flip it upside down. The IAC valve is mounted by two screws to the throttle body, and it has a gasket that you will need to replace if you remove the IAC valve, so make sure you have a new gasket on hand if you intend to take off the IAC valve.

The Idle Air Control (IAC) valve is mounted on the throttle body

The IAC (Idle Air Control) valve is faulty.

where is the iac valve for 2003 expedtion Eddie Bauer

where is the iac valve on a 99 honda civic lx?

Where is the iac valve located on 2004 dodge 5.7hemi

The IAC is located on the throttle body.

A vacuum leak or a faulty IAC (Idle Air Control) valve.

The location of the IAC valve depends on the kind of fuel injection system you have. On the Vortec V6 (93+) it's right on top of the air intake in front of the throttle valve. If you follow the air intake tube to the motor, the IAC valve will be in the intake manifold right where the air tube meets the manifold. The wiring for the IAC valve comes around behind the throttle cable bracket and plugs into the IAC valve.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.