answersLogoWhite
Ask
GM and GMC

How do you put a serpentine belt on a 1995 Dodge Caravan 3.0 engine?

303132
Answer

Top Answer
User Avatar
Wiki User
2015-07-16 18:22:39
2015-07-16 18:22:39

locate the "tensioner" pulley, on the schematic that is under your hood, on top of the radiator. Then place a socket on the bolt head in the middle of that pulley, and with a breaker bar, pull the entire pulley towards the front of the van, releasing the tension, and letting the belt slip off easily. Repeat this procedure once you have the new belt routed around most of the pulleys properly and slip it over the tensioner pulley last. Double check belt alignment on all pulleys, make sure it is well tensioned, then start your van and let it idle about 5 to 10 seconds, shut it off, and recheck the belt alignment and tension. If all looks well, then close the hood and call it a job well done.

1
0

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.