instructions for replacing air filter on 1989 Buick Skylark 4 cylinder
A 1989 Honda Accord has a timing belt.
In a 1989 Nissan Pulsar NX : The 1.6 litre four cylinder engine has a timing CHAIN The 1.8 litre four cylinder engine has a timing BELT
TIMING BELT for the 2.7 liter V6 engine in a 1989 Acura Legend
how much play should a 4.3 Chevy engine timing chain have?
CVC joint needs replacing. This can be dangerous, have it repaired.
I believe that model has coil packs located at the end of each pair of plug wires. Mark
In a 1989 Mercury Sable : Both the 3.0 and the 3.8 litre V6 engines have a timing CHAIN
use a section of 5 ft hose and suck on it till gas comes out to syphon
chain, to the best of my knowledge belts were never used on the 3800.
Trade it in for a Vette or something... You dont. And the 89' skylark gets WAY more than 7 miles to the gallon. I get about 20-23 in the city and 32 on the highway.
According to the Gates website ( they make timing belts etcetera ) The 3.0 liter V6 engine in a 1989 Ford Taurus SHO has a timing BELT
No, it has a timing belt which must be changed every 60,000 miles.
Recommended should be in your manual or a tire store can look it up. If your spare is original & not a space saver, check the blackwall.
Listed on the driver's door post.OEM Sizes 205/70-13 or 215/60-14
I would suspect you need a new timing chain or belt depending on which is installed. A worn belt or chain will jump time.
most likely a belt, mine has the belt
Normally an engine this old that needs a new timing chain, also needs an overhaul. I cannot tell you in this limited space how to change the chain and gears. I suggest you purchase a Haynes, or Chilton's repair manual.
The 1989 Nissan Stanza 2.0 4 cylinder has a timing belt. This is also an Interferance Engine, and as such if the belt breaks, serious engine damage will occur. The belt should be replaced at 60,000 miles.
Yes it should be on the far right of the engine
The timing on a 1989 Dodge truck should be set to 10* after unplugging the temperature sensor.
Sounds like a torque converter issue, have it checked at a transmission shop