Your water pump should run off of the serpentine belt. there shouldn't be a separate belt for the 4 cylinder. if you change the serpentine belt, there is a belt tentioner in the middle. using a wrench, not a ratchet(the ratchet will not have enough room to fully turn the tentioner), turn all the way to the right, remove the worn belt and replace it with a new one, following the belt diagram on the inside of the passengers side fender.
Drain the water from your 1989 Chevy Cavalier cooling system. Remove the water return hose from the water pump. Remove the water pump belt. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
How do you replace timing chain & water pump on a2001 Chevrolet cavalier
opposite of the way you took it off before changing your water pump
On the drivers side (Australia)/ passenger side (America) at the back on the bottom of the engine. The main belt it connected to it.
Drain the radiator on the 1988 Cavalier. Take of the water pump belt. If the fan and shroud are in the way then remove them. unbolt and remove the pump. Bolt up the new pump and put the belt back on. Put the shroud and fan on if they were removed. Fill the radiator back up.
If this is a 4cylinder motor, the water pump is located in with the timing belt,and should be replaced by a qualified mechanic, this is a interference motor, if timing belt is not properly installed, motor damage will result. Bent valves, holes in pistons,etc.
Drain the radiator. Remove the pump belt. Remove the fan and shroud if needed. Unbolt the pump and remove it . Bolt on the new pump. Reinstall the fan and shroud, the belt, then refill the radiator.
If you have a 2.2 liter 4 cylinder, the water pump is under the alternator on the passenger side and below the serpentine belt tensioner.
It's one of your belt driven accessories-that's a starting point.
To replace the Cavaliers water pump, drain the radiator. Remove the pumps drive belt. Unbolt the pump and take it off ( you might have to take the fan and shroud off to get to the pump.) Install the new pump and put the belt back on. Refill the radiator with antifreeze.
Drain the radiator. Remove the pump belt. Remove the fan and shroud if needed. unbolt the pump and replace it with the new one. Reinstall the fan, shroud, and belt. Fill the radiator with coolant.
It is behind the timing belt cover and is driven by the timing belt. There are various arrangements according to which engine is fitted.
Typically about 80-90 thousand miles
Drain the radiator. Remove the fan and fan shroud if needed. Remove the pump belt. Unbolt the pump and remove it. Install the new pump. Reinstall the belt, fan and fan shroud. Refill the system with new coolant.
the water pump is run by the timing belt the water pump is where the timing belt at in the motor
What is the cost to replace a watrr pump on a 97chevy cavalier
On most engines, the water pump drive belt is also the timing belt.
The water pump is powered by either a drive belt or serpentine belt. Follow the belt and you will locate the pump.
If the timing belt drives the water pump you should replace the belt at the same time as the pump.
Yes, the water pump on a 3.5L is timing belt driven.Yes, the water pump on a 3.5L is timing belt driven.
the water pump is part of the timing belt or chain. you have to take the belt or chain off to change the water pump. if you change the water pump, change the belt too.
The water pump is driven by timing belt, so, replace the timing belt while you are replacing water pump, because you have to take off timing belt to get to water pump.
The water pump is under the timing belt cover. The front most pulley the timing belt runs on is the water pump pulley. The water pump is located under the timing belt cover. The front most pulley the timing belt runs on is the water pump.
the water pump is turned by the timing belt and it is recommended that you change the belt at the same time as the water pump
The water pump is driven by the timing belt.