answersLogoWhite

0


Best Answer
Copy

If it has a center cupholder/console, it should have a Phillips screw in the middle in order to attach it. So, you must unscrew the console, replace the engine cover (or "shell") and reinstall the console. Be careful as to not to fasten the shell latches in the farther loops of the cockpit locks, since they may lock in on one side or the other, but they won´t allow the other end to fasten or even reach in. You might be tempted to force them by using a lever-like screwdriver or the like, but it would damage such latches and thus smoke, dust and a lot of noise would invade the cockpit. If it doesn´t snap in easily by hand, it is not properly in place.

2011-09-13 06:06:14
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Where is the timing belt in an 03 Saturn Ion?

Ion's have timing chains and they are on the front of the engine. Requires removal of front engine cover and rocker cover to access


How do you remove interior engine cover Chevy express van?

It depends on the model year and size of engine cover based on the engine underneath. For 1996 and newer, you generally have to remove the passenger seat in order to get the cover out of the way.


How can I remove the engine cover on a Ford aerostar 1992?

if your talking about the engine cover inside the van under the dash! on each Sid eof it back under the dash there are 2 latches on each side un latch them and carefully pull it out!


How do you open the inside engine compartment on a 1993 ford aerostar?

Remove the Phillips screw in the cup holder. Reomver the holder. Release the four latches on the engine compartment cover. Rotate the cover down and to the rear of the van. Tight fit


How do you get the engine compartment unlatched on a 1989 astro van?

there are also two bolts under the hood that hold the interior engine cover on


1994 ford aerostar How to remove the interior engine cover?

Remove the screw in center cupholder then remove it.Under dash take out the 2 8mm nuts that hold rear abs module in.Unhook the 3 retaining hinges then push up on cover wiggle it a little left and right until it comes loose then pull down and out.


What could cause a ford aerostar 3.0 engine to lope at idle speed?

Check: 1.- PCV vacum hoses 2.- Engine oil cap looseness. 3.- rocker cover gasket


Removing the engine cover on Chevy astro van?

Refer to your owner's manual for specific instructions of the removal procedure for your Van's year. There are some typical drawings at http://astrosafari.proboards.com/index.cgi?board=interior&action=display&thread=28&page=1


Does Arkansas medicaid cover the removal of Mirena IUD?

All Medicaid programs cover removal of an IUD.


Would insurance cover the removal of breast implants?

Could ins cover the removal of my Brest implants


Where is the Interior fuse box for a 2006 jeep commender How do you get the cover off?

The 2006 Jeep Commander does not have an interior box. The fuse box in the engine compartment is the only fuse box.


Need to find and replace the camshaft sensor on a 95 Ford Aerostar 3L?

IF it is the same as the 1997 3.0L, then remove the engine access cover inside the vehicle. It is atop a shaft called a synchronizer at the rear top of the engine. It is attached with two small bolts.


Do you have to remove the interior engine cover to replace the PVC valve on a 2002 Chevy Astro van?

Yes it would be easer to get at it with the dog house removed.


Where is the fusebox on a 93 Ford Aerostar?

Look below and to left of steering column for access cover.


Where does it say the size of the engine on the engine?

Generally on top on the valve cover or engine cover.


How to remove engine cover?

To remove the engine cover on an Aerostar, first remove the two screws that hold the "black box" to the underside of the dash, below the ahstray. it is NOT necessary to unplug it! If there is a cup holder, remove the screw holding it and pull the rear up, until the friction fasteners let go. There are three latches, two on the right, one on the left. Release and clear the latches, move the cover down and rearward.


Who is the founder of the removal of phobias?

Mary cover jones


Where is the oil filter located in 2011 Dodge Journey?

It's accessed from the TOP of the engine under a removable (twist) cover on the passenger side of the engine cover.It's accessed from the TOP of the engine under a removable (twist) cover on the passenger side of the engine cover.


Where is the oil filter on 3.6L Dodge Journey?

It's accessed from the TOP of the engine under a removable (twist) cover on the passenger side of the engine cover.It's accessed from the TOP of the engine under a removable (twist) cover on the passenger side of the engine cover.


How hard are valve cover gaskets to change on '91 40l Van reeks of burn oil after 5 minutes Whats the likely source?

4.0 valvecover gaskets aerostarthe trick to replacing the valve cover gaskets on a 4.0 aerostar is to remove the engine supports and letting the pan rest on the crossmember. this should provide enought clearance to remove the covers through the wheel well. don't forget to purchase the pleneum gasket as well. it has to be removed to change out the drivers side cover. it is a difficult job, but not impossible. be sure to checkfor any hard fitted lines attached to the engine before you lower it to avoid damage.


How do change the internal oil filter on a 2011 Dodge Journey?

It's accessed from the TOP of the engine under a removable (twist) cover on the passenger side of the engine cover.It's accessed from the TOP of the engine under a removable (twist) cover on the passenger side of the engine cover.


Where is the headlight relay switch located on a 1992 Aerostar?

located behind the battery under a black plastic cover


What size are the bolts on the transmission filter cover of a 1995 ford aerostar?

most likely a 10mm or a 3/8"


Where is the fuse for the interior lights in in 2000 Dodge Caravan?

If I remember correctly the fuse box is located under the hood on the drive side of the engine. You have to remove the cover to exspose the fuses... the inside of the cover should identify the appropriate fuse.AnswerIf I remember correctly the fuse box is located under the hood on the drive side of the engine. You have to remove the cover to exspose the fuses... the inside of the cover should identify the appropriate fuse.


How do you get to the rear speakers on a 1992 GMC sierra extended cab pickup?

If there are not screws in the speaker cover on the pillar then you will have to remove the entire section of interior trim. You need to use a trim removal tool to carefully pry by the fasteners.