You can raise the alkaline level if your pool water by adding sodium bicarbonate (aka baking soda). It is recommended that you raise the alkaline in small increments because it is easier to raise your total alkaline levels slightly if its a little too high or too low. This chart from swimming-pool-care.com gives out how much sodium bicarbonate to add.
Desired increase in PPM1,000 gallons5,000 gallons10,000 gallons20,000 gallons50,000 gallons100,000 gallons10 ppm2.24oz11.2oz1.40lbs2.80lbs7.00lbs14.00lbs20 ppm4.48oz1.402.80lbs5.60lbs14.0lbs28lbs30 ppm6.72oz2.10lbs4.20lbs8.41lbs21lbs42lbs40 ppm8.97oz2.80lbs5.60lbs11.2lbs28lbs56lbs50 ppm11.2 oz3.50lbs7lbs14lbs35lbs70lbs60 ppm13.4 oz4.20lbs8.41lbs16.8lbs42lbs84.1lbs
Sodium Bicarbonite
Remove some water in container (10-20%) and add new water. example: pump water high in cyanuric acid out of a swimming pool and the add fresh water to the pool.
Because you're a doucher with a pool.
You whip your dick out and pee in the pool.. that oughta do it! :)
A good way to see if you have a leak in your pool is to # take a bucket and fill it with water from your pool. # mark it at the water level. # mark the pool at the water level. # wait a few days if there is no leak in the pool then the water level in the bucket should have reduced by the same amount as the water level in the pool, however if the water level in the pool has gone down more then the water level in the bucket you have a leak in the pool or in the pipes around the pool.
If you have a deck level pool or spa (water level with the top of the pool, that usually overflows into a grating around the pool) when people get into the pool their body displaces water, this water is stored in the Balance tank until the people get out and the water is pumped out of the balance tank and back into the pool. A skimmer pool that has a lower water level than the top of the pool does not need a balance tank as the displacement is handled by the water level rising. Deck level pools and spas are considered more aesthetically pleasing.
Hardness increaser from your pool supply company
Baking soda will almost certainly raise the pH level in a pool.
You add water to the pool
how to raise ph level from 6.2 to 7.4? Chlorine is 3.
You need to know how what size your pool is. But to raise your salt level 1000 ppm, add approximately 80 lbs of salt for every 10,000 gallons of water. Adjust tequila and lime to taste.
Check to see if there is a leak in it. You can do this by taking the cover of the pool and marking the water level, then take a bucket of water mark the level on it. place the bucket next to the pool and leave it there for a few days. if the level in the pool drops the same as the level in the bucket then the reduction of water is the result of evaporation. however if the level in the pool drops more then the level in the bucket you are loosing water somewhere.
Use Soda Ash to increase the PH level. Baking soda can be used to maintain the alkalinity of the pool water. Just the opposite!!!! Baking Soda will increase or raise the alk. Soda Ash raises the pH. Muriatic Acid lowers pH. k