Headlights Tail and Brake Lights
Chevy G20
Toyota 4Runner

How do you re-center the proportional valve to get the parking brake light to go off in your 1992 Chevy G20 Van?

585960

Top Answer
User Avatar
Wiki User
2015-07-15 18:55:55
2015-07-15 18:55:55

First Bleed the rear brakes then the fronts. Check the brake fluid in the resivore. Also check the the E-Brake switch is working properly, Then drive the van a few feet an cram on the brakes hard.

If previous suggestion does not help, there is a chance that the valve is jammed and will not center. Replacement may be necessary.

Just take your foot and stomp the break pedal real hard, 4 to 5 times.

This should push the ball back over. Give it a try. Works for me.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The 1998 Chevy Corvette parking brake can be adjusted with the parking brake adjustment bolt. You can also adjust the parking brake cable.

User Avatar

The 2001 Chevy Cavalier parking brake has an adjustment bolt on the parking brake assembly. Turn the adjustment bolt to loosen or tighten the parking brake.

User Avatar

On a 1998 Chevy Blazer, the parking brake switch is located on the top of the parking brake assembly. There are 3 bolts that hold the switch to the parking brake assembly.

User Avatar

How do you adjust the parking brake on a1994 Lumina?

User Avatar

The 2000 Chevrolet Impala parking brake will have an adjustment bolt on the parking brake assembly. Turn the adjustment bolt to loosen or tighten the parking brake.

User Avatar

my parking brake release did not take off the parking brake on my 2001 chevy s10? is there a way to disengage it?

User Avatar

You may be low on brake fluid or the parking brake linkage needs adjusting.

User Avatar

i was never know what is the answer ,

User Avatar

That's what I am asking you. How do you replace a parking brake handle on an S-10 1996 Chevy Blazer?

User Avatar

frist make syre your rear brakes are ajusted properly then try your parking brake

User Avatar

The parking brake on a 2003 Chevy Suburban are adjusted by increasing or decreasing pressure on the spring. This is done under the vehicle, along the middle of the vehicle's frame.

User Avatar

You might have an ABS problem or a problem with the brake master cylinder. Check the fluid level in the brake reservoir.

User Avatar

Check the switch and/or make sure the parking brake pedal is all the way up if it is not that might be air in your brake lines or leak

User Avatar

The parking brake on these vehicles are basically self-adjusting. Fully apply and release the hand parking brake lever 4-6 times to self-adjust.

User Avatar

To see a diagram of a Chevy S10 parking brake system you can visit your local auto parts store. The store will have a diagram that you can look at or will able to order you one.

User Avatar

Apply your parking brake a bunch of times.

User Avatar

Take off the brake caliper, and brake rotor, under the rotor is a parking brake shoe, that is probably wore down and needs replaces. I

User Avatar

If it's all the way over on the left, it's the parking/emergency brake. You set and release the parking brake with this pedal. If it's right next to the brake, it's a clutch.

User Avatar

Chevrolet Blazer parking brake can be adjusted with the adjustment screw on the parking brake pad. The parking brake can also be adjusted with the parking brake cable.

User Avatar

The BRAKE(!) light will go on steady without the parking brake on.

User Avatar

how do you adjust parking brake

User Avatar

2001 #2500 series rubber gromet on backing plate , remove , parking brake adjustment shoud be visable . use brake adjusting tool to rotate star wheel on inturnal parking brake to losen P. brake. then remove brake rotor and pads check P Br. shoes alot of work! mike s.

User Avatar

The 2004 Kia parking brake can be adjusted with the parking brake adjustment bolt. The adjustment bolt will be on the parking brake pad.

User Avatar

The 2000 Oldsmobile parking brake can be adjusted with the parking brake adjustment bolt. The adjustment bolt will be between the parking brake pads.

User Avatar

To release the parking brake, hold the regular brake pedal down with your right foot. Push down momentarily on the parking brake pedal with your left foot until you feel the pedal release. If the parking brake is not released when you began drive, the brake system warning light comes on and s chime sounds as a warning that the parking brake is still on.Manual Book page 2-28


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.