Electric Windows
Chevy Impala
Lincoln Continental

How do you reattach a drivers side window on a 1996 Lincoln Continental?


Top Answer
User Avatar
Wiki User
2008-05-11 23:12:01
2008-05-11 23:12:01

There are a few ways to this. You can take the window out or leave it in.

1.) remove the door panel and pull back the sticky paper.

2.) After you do this, push the window up, clean the class and clean the two clips on the aluminum arm

3.) Use a silicon or if you want an epoxy to fill the two clips the window sits in and lower the window back into these two clips.

4.)use the window button to close the window and let the epoxy or silicon cure. I usually wait 1-2 days.

5.) You should be good to go until the next time it happens


Related Questions

User Avatar

How do I replace the washer on my 200 Continental? Don

User Avatar

The window motor on a Lincoln Continental is replaced by removing the door trim, disconnecting the wiring harness to the motor, and unbolting it from the door. A new motor can then be mounted and hooked up.

User Avatar

i know the rear window relays are in the trunk, on the backside of the back seat. there are 4 of them.

User Avatar

You do not reattach any mechanism. You will have to replace the window regulator.jd

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.