American Cars
Air Conditioning and Coolant
Ford Trucks and SUVs
Ford F-150
Ford Escort LX

How do you recharge ac on Ford F-150?


Top Answer
User Avatar
Wiki User
2007-05-20 01:11:44
2007-05-20 01:11:44

Buy a kit at Wal-Mart or auto parts store - comes with instructions


Related Questions

left side on firewall should be on the side of ac condencer

The AC recharge port on a 2008 Ford F150 is located close to the hose that runs from the compressor to the accumulator. The hose is the low-pressure hose and you will notice a service fitting on the hose which is where the port is.

where is the ac recharge port on a 93 ford explorer located?

Its on the Receiver Drier/Accumulator. I found a drawing of it on the site listed below.

The AC recharge valve for a 2003 Ford Focus with a Zetec engine is near the firewall. It is the larger of the two lines going to the compressor.

To recharge the AC on the 2002 Ford Escort ZX2 you need to use the low pressure fill port. It is located on the larger of the two hoses coming off the compressor.

The recharge port is located on the passenger side near the firewall.

I need a step by step print out of how to recharge my 2001 Ford Escape XLT. I plan on refilling with R-134 Freon. Can you help me?

How do i Recharge AC Unit for a 1998 Dodge Stratus

Should be a valve on the firewall on the passenger side you need a a/c kit

Buy a kit at Wal-Mart or auto parts comes with instructions

Diagrams of a 2001 Ford F150 AC system can be purchased at any auto parts store. If the store does not have it in stock, it can be special ordered.

The AC port for a 1999 Ford F150 is in the back of the engine compartment near the firewall. It is the larger of the two hoses going to the compressor.

Take it to a garage that services ac. If it needs a recharge it must have a leak in the system.

where is the low pressure port for the a/c -- 93 ford ranger 4.0L -- super-cab

it is on the passenger side of engine back by the firewall. it is a little hard to get to.

Both of these ports are located in the lines coming from the compressor. According to Alldata.

If it is a factory ac the front and rear use the same ports. It just takes more freon for one with dual units

91 will have r-12 freon but can be converted to r-134a easily

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.