answersLogoWhite

0


Best Answer

This is not a job to be done by a backyard mechanic. The pressures are irrelevant as you will have to take this to a shop to be done anyway.

Not sure why anyone would say you need to take it to a shop just for a recharge. Since around 1995 when manufacturers started using R-134 "freon" instead of the old R-12, charging a system has gotten a lot easier. The fittings are different for the low side (suction) and the high side (pressure), so you can't connect to the wrong port.

You can get cans of R-134 from Wal-Mart for under $9.00 (12 oz.), and even get the lows side hose kit (usually blue in color to indicate low/suction/cold. But for about $17.00 at Autozone, they have a low side kit that has the "puncture" fitting to connect to the can, a hose that connects to the suction port on the car, and a built-in suction gauge marked for the desired suction pressure.

Basically, open up the puncture valve so it is back from where the can connects, connect it to the can, connect the other end to the car's suction port (only fits the correct port), then start the car. Run the A/C full on, windows down, max cool. Now, close the puncture valve so it pierces the top of the can, then as you open it up, R-134 will be sucked into the A/C system. You can probably point the can downward while it is filling, and you can always feel the hose-end of the can getting colder as freon enters the system.

Once the can feels real light, and the end doesn't feel cool anymore, you're probably done, Usually, if you had been feeling a small amount of cooling before, one can will be enough to fox things. Close the valve, tun the engine off, then disconnect the hose from the car. Replace the protective cap that was on thew valve in the first place - this protects the valve from dirt, but more importantly, it makes sure the freon doesn't leak out the service port. There should be a cap on the pressure point as well. If either cap is missing, get a replacement from an automotive parts store.

Don't let anyone tell you that you "have" to take it to a shop. As long as the "parts" are working OK, a recharge is pretty easy.

...................... Above is correct, and do not get discouraged if everything does not work perfectly (cold air) at first. Mine took a couple of days to re-lubricate the compressor and function correctly. The cost was $21.oo, and patience, instead of 350.oo at a shop.

[bjranson] Agreed. I just did it with a R134 can/pressure gauge kit from Walmart - $24. Very straightforward, and this is the first time I've ever done such a thing. The guy who said take it to a mechanic is probably a mechanic himself and doesn't want to lose business and hundreds of $ to DIYers. Either that or he's just scaremongering.

User Avatar

Wiki User

βˆ™ 8y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

βˆ™ 12y ago

It will have to go to a garage with the correct equipment to evacuate the system and then recharge it, its not possible to do this at home.Hope this helps

This answer is:
User Avatar

User Avatar

Wiki User

βˆ™ 17y ago

buy a recharge 134a conversion kit from wallmart one of them has a instruction video on a cd.its vary vary easy!just be plz be carefull lots of pressure in those cans

This answer is:
User Avatar

User Avatar

Wiki User

βˆ™ 14y ago

If you don't know what you're doing, then you should take it to a mechanic (I got my car recharged for $30.)

This answer is:
User Avatar

User Avatar

Wiki User

βˆ™ 16y ago

Freon administered into your ac unit!

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What pressures do you need to recharge the air conditioning system on a 97 Jeep Cherokee?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Music & Radio

Does the upstairs air conditioning system need to be on for the downstairs air conditioning system to work more effeciently?

no..


How does one charge the air conditioner on a 1993 Jeep Grand Cherokee Limited?

First you need to find out if the system is a 134a system or not. It is then it recharged through the low port using one of those recharge kits from Walmart or Autozone or wherever. The port only fits on one side. If it is not a 134a system then you will have to have the expensive older freon put in or get a retrofit kit. The later is cheaper. Then refill with 134a. If system has been opened up then the system will have to be hooked to a vacuum pump and then filled with the proper amount of refrigerant and oil. Hope this helps.


Where can you get a picture diagram of complete air conditioning system for a Jeep Grand Cherokee?

I got one from my Jeep dealer today - just walked in and pretended to want to buy a drain tube and the dude did not know about what part it was so he went off and printed out 3 pages of explosion diagrams. I am in Australia.


Location of 99 Jeep Cherokee 4.0L heater core?

Changing the heater core requires complete removal of the dash panel and plenum box. To do this you have to remove the steering wheel, steering column, evacuate and recharge the refrigerant system and drain the radiator. I would only consider changing the heater core if it is physically leaking into the passenger compartment. If the problem is heat transfer to the HVAC system only, the problem is more likely with the blend doors.


Is a system relearn required after adjusting the air pressure on a 2004 Jeep Grand Cherokee?

True

Related questions

How do you recharge the air conditioning system on a 1997 Jeep Grand Cherokee?

Buy a kit at Wal-Mart or auto parts comes with instructions


Where is the recharge line for the AC on a 1990 Mitsubishi mirage?

The 1990 Mitsubishi does not have an air conditioning recharge line. The vehicle has an air conditioning recharge port. You can recharge your air conditioning system through the low pressure port on the air conditioning compressor.


How do you recharge the air conditioning on a 2003 s type jag?

where is the low side port to recharge the air conditioning system in a 2003 jaguear s type


How do you recharge ac in 2001 huyndai accent?

The easiest way to recharge your air conditioning system is with a recharge kit. The recharge kit will come with one pound of Freon, a gauge to tell you when the system is full, and instructions.


Where is the air conditioning recharge valve on a 2003 Ford Explorer 4.6?

The air conditioning recharge valve on the 2003 Ford Explorer 4.6 is located on the low pressure side of the air conditioning system. Located on the line coming from the accumulator to the compressor is the recharge valve.


How do you recharge air conditioning on 1995 jeep?

It will have to go to a garage with the correct equipment to evacuate the system and then recharge it, its not possible to do this at home.Hope this helps


How do you recharge air conditioning on a Montana?

There are two ports on the air conditioner compressor on a Montana. Attach the refrigerant to the lower port and recharge the system.


Where do you recharge the air conditioning on 2005 Kia Sedona?

You can recharge your 2005 Kia air conditioning system from the low pressure port. The low pressure port can be found on top of the air conditioner compressor.


How do you recharge the air conditioner for a 2001 Bonneville?

The easiest way to recharge your air conditioning system is to purchase a recharge kit. The recharge kit will include a one pound bottle of Freon, a pressure gauge, and instructions.


Where do you recharge your AC on a 98 mercury mystique?

You can recharge your 1998 Mercury Mystique air conditioning system through the low pressure port. You can find the low pressure port on top of the air conditioning compressor.


Chevy Impala ac recharge?

Attach the Freon bottle to the low pressure port on the air conditioning compressor. Release the Freon into the air conditioning system. A recharge kit can make this process very simple.


Where do you recharge the AC on a Mercury Mountaineer?

There are two ports on the air conditioning compressor on the Mercury Mountaineer. The refrigerant to recharge the system is to be connected to the lower port.