With some difficulty. You can use a resistor in series to drop the voltage, or you can use a zener diode. If you want to be elegant you get a DC-to-DC converter and set it up to do the job for you.
A series resistor will work only if the load current doesn't vary.
A: At that low voltage a supposed to be zener could be a series of diodes. Anyhow you must first determine the load at 3.5 volts then add 5 to 10 ma for the zener for total current. a resistor must be placed in series with the zener and its value would be 12v -3.5v divided by total current.
Generally, there will be a 12+ volt rail, a 5+ volt rail and often a 3+ volt rail.
120 volt single phase rectifies to about 96 volt DC
No. You need 12 volt AC to run a 12 volt AC motor, not 12 volt DC.
You may get some sound out of the unit but not at the fidelity that the manufacturer designed the speaker to produce.
A variable power supply has a control to adjust the DC output voltage from 0 to 12 volts. It is used for testing electric project's such as amplifiers and other electric devices. It can be used to replace other fixed voltages power supplies such as the srandard 3 volt, 5 volt, 9 volt and 12 volt units.
With an invertor/rectifier or voltage multiplier.
With an appropriately rated DC to DC converter.
Type your answer here...
can ou step down 36 volts dc to 12 volt dc using batteries
No. The value and polarity are different.
Generally, there will be a 12+ volt rail, a 5+ volt rail and often a 3+ volt rail.
Use a properly rated potentiometer.
120 volt single phase rectifies to about 96 volt DC
All Batteries are DC or Direct Current.
No, it is the same. DC stands for direct current rather than AC, which is alternating current.
No. You need 12 volt AC to run a 12 volt AC motor, not 12 volt DC.
12 Volts DC