answersLogoWhite

0


Best Answer

What do you mean... reflash?

Trying to get comp codes?

Trying to clear all comp codes?

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you reflash the computer on a 1998 astro van with a 4.3L?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How many kL are in 43L?

.043


How many liters in 43ml?

.43L. 1000ml=1L


What transmission came in the 2002 43L s-10?

4L60/E l


Does a Chevy 305 mount to the same transmission as a 43L?

Yes it will bolt right up to it.


How can you calculate the mass or the volume of 18-k gold?

43L of 18-k gold


Where is the Oxygen Sensor on a 90 Caprice V6 43L?

There is one before and one after the catalytic converter.


Where can you check fuel pressure on a 1990 V6 43L Chevy Siverado?

The fuel lines around the filter; you will need an adapter.


How do you clean and adjust the throttle body on a 1991 Chevrolet S-10 blazer 43L is it the same as a carburetor?

There is no adjustment required, but you can clean it with a carb cleaner.


How do you change the stock single exhaust to dual on a 1994 43L Caprice?

Use an exhaust made for an LT1 engine the blocks are identical it is the insides that is different. Will bolt right on.


Can you swap a 3800 supercharged 38l from a gtp into your 95 Chevrolet cheyenne that's two wheel drive and already has a 43l v6?

What year is the gtp, if 95 or newer yes, if gtp is in the 80's then no due to pollution restrictions today, and may have to change the computers from each vehicle. Each computer is set to specs for the engine it controls.


1998 Chev Blaz 4wd 43L; crazy electric - the doors lock-unlock themselves with the vehicle off and keys out of ign I apply brakes -dash lights dim and dome lght comes on Bat and alt are ok any ideas?

sounds like an earth problem to me, check and clean all your earth points though i suspect its more of an earth failure


Where is the engine timing mark on an '86 Chevy Astro 43L?

I have a '90 so I think it would be the same, on mine it is at the front of the engine on the bottom pulley. (crankshaft pulley or vibration dampener) To view the scale and mark I have to look down, a little on the drivers side of center. Beside the break resivour is a good viewpoint, looking just over the timing light. I have to run the timing pickup coil in through the drivers door or window and into the open doghouse cover. Good luck. God Bless!