Leave vehicle in first gear, to prevent movement, Jack Up rear end of vehicle, remove road wheels, release handbrake lever, hit rear hubs with hammer then try to spin hub, this should work, with rear disc brakes such as 309gti be careful not to damage disc or pads whilst hitting with hammer!
its underneath the handbrake go under the car where the centre exhaust is there is heat shields remove them and its there a 13mm nut wind it in till cable tight but with a bit of slack onit job done
how do you change the handbrake cable on a 1997 Toyota rav4
replace it.
It is very easy to adjust the handbrake on a Vectra C. All you need to do is remove the rear console and release the handbrake. Under the handbrake is a cable with a white end fitting, push down the end fitting onto the plastic locking device. Then pull the lever and it will be adjusted.
i dont no
its normally mechnical so find the steel cable and find the nut on the cable of the parking brake "handbrake" and tighten
How do you remove handbrake cable from brake caliper 3litre signum right hand side
very careully
change hand brake cable citreon relay
Release the handbrake, pump the brake pedal a few times to settle the brakes, then apply and release the handbrake a few times. The rear brakes are self adjusting so be careful not to over do it or you will end up locking the your drums. If this does not work, then you need to get the tools out. Jack the rear of the car up, use axle stands for safety. Slacken off the handbrake cable adjuster nut, lift handbrake lever up 4 clicks, tighten handbrake cable adjuster nut until it takes up the slack, check rear drums rotate freely, job done.
change hand brake cable citreon relay
If it has rear drum brakes, it's under the car, where the handbrake cable emerges from inside the car. If it has rear disk brakes, there is addition adjustment inside the rear disks on the handbrake shoe mechanism. This adjustment should be carried out before attempting to adjust the cable.