First you need to remove the ashtray (pull it open and push down on the little tab on the top and pull it out) then you have to pry on the trim. Do this slowly as you could break it. it will take a good pull. (it's just clipped on) then remove the moulding that goes around the astray/lighter area. This is done by removing 4 screws (2 on the top sides and 2 located on the bottom at the back. look close they're there) then you will have free access to the 2 bolts holding in the radio. nothing really tricky about it except trying not to break the first trim piece.
How do I change th starter on a 1994 Plymouth sundance
Remove the tire and wheel from your 1994 Plymouth Sundance. Remove the brake assembly spring. The brake pads will come off. Reverse the process to install the new brakes.
No. It Is Held In Place From The Bottom .
No, it is not an interference engine.
you need a 10 amp (red) fuse for the radio. the fuse is located in the top right fuse corner of the fuse panel. it is marked radio underneath the fuse.
The codes on a 1994 Sundance are 2 digit codes. Code 3 is not correct.
You can purchase a dipstick from the dealer.
in the fuse box
It is screwed into the exhaust manifold on the rear of the engine.
A 1994 Plymouth Sundance/Duster does not use a speedometer cable. Instead, it uses a Speed Sensor located on the transmission.
Front camber is adjusted at the strut to knuckle bolts.
passenger side rear next to fuel tank
I believe the flasher is up in, under the dash, to the right of the steering column. If it is, the best means to get to it is to remove the bezel for the radio and heater controls. At this point, depending upon exactly where it is, either the radio or heater control package must be slid out so you can reach the flasher. Not the most convenient place to put it.
Go to www.crutchfield.com or call them.
Electrical located in the fuel tank
It would greatly help to know what engine you have and if it has air conditioning (working or not)
Remove the retaining cover from your 1994 Chevy S 10 pickup truck radio. Remove the radio retaining bolts. Slide the radio out. Remove the wiring harness and the antenna cable from the back of the radio.
... on a 1990 Sundance there is a flasher just above and behind the radio - it seems to control the right side flashers. The 'bezel'type trim piece surrounding the section of the dash containing the radio can be pryed off. I would sure like to know where the flasher for the lights on the left side is ...
Remove the 1994 be a week Century radio decorative cover. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness and the antenna cable from the back of the radio. Reverse the process to install the new radio.
Code 43 refers to the coil. Code 55 is end of message.
My husband And I just changed the tank on our 89 Sundance. Make sure you remove srews from plastic cover piece inside fuel door. Undo the straps from tank. There are also a couple of bolts there to hold tank, close to the back from underneath. THen you have to slide tank over everything there. Not real hard to do.
My child seat car bolt, is in a 1988 Sundance, passenger side about 1 ft from behind back seat, on trunk floor.
you have to remove the dash
The bulb is falty, replace it and it should cure your problem.
The engine computer is the rev limiter. It controls max rpm by shutting off fuel and ignition.