It really isn't hard but you need direction. Get a manual on your car from AUTOBOOKSONLINE.COM
Jack up the car and place jack stands under a solid area Peen the safety lock on the axle nut with a hammer an chiesel Remove the axle nut with a strong impact gun and a 1 1/4" socket Remove the brake caliper & hang it with a tie wrap Remove the brake shoe housing Remove tie rod from spindle Remove the ABS wire harness clip in strut Remove the 2 strut bolts with a 17mm socket and wrenches Remove lower ball joint locking bolt Swing down spindle assembly and remove axle assembly from outer splines Knock out axe from transmission side
Note: If axle is seized in hub, spindle assemble must be removed with axle attached and then heated and removed.
Counter clockwise Is that counter clockwise to tighten or loosen? (i.e. RH or LH threads)
no, they are different body styles.
Negative......V6 uses different trans than I4
no, the 89-92 engine/transmissions are different from the 93-97 ford probe.
Were do I locate the fuel filter on a 1993 Ford probe 4 cylinder
Yes, year model 93 thru 97 Ford Probe
They are on the camshaft and crankshaft sprockets
Nope 98-94 is one model. 95 starts a new design.
noAnswerno the only years that will work are 93 to 94 ford probe, 93 to 94 Mazda 626, and 93 to 94 Mazda M6 and if its a (CD4E) Transmission good luck you will need it! Answerthe tranny form a 93-95 should work i swaped my auto out to a 5 speed from a 95 and my car is a 93 works fine few extra parts left over
Yes,but the 93 and 94 enginges are obd1,while the 95-97 are obd2.
No, they are completely different motors with different wiring harnesses, motor mount positions and transmissions.
The fuel injector
Brand New 1993 Ford Probe right off the show room floor cost me "$29 800.00"
the computer is located behind the shifter under the radio
It has 134 A the change was around 92 93
No it won't. I had a 95 Ford Probe Se 2.0L and when the transmission went i upgraded to a 93 Probe Gt 2.5L V6 and my insurance didn't change at all. I love the car.
If it is an automatic than it is probably the torque converter
The 93 ford probe came with Mcpherson struts all the way around. I am not sure if the base model included rear shocks, but I doubt it. Stan
89 to 93 just worked on one.
if you can see the dipstick you put it in there if not there will be a tank in the engine
Click the link
When my 1997 Ford Probe started to do that we toke a look at it and found a few leaks in the Air Intake
ford probe is the same engine/transmission configuration
how do you take off drivers side axle- 93 escort wagon? Kevin