How is the radio remove on a 2008 Chevrolet silverado?

Answer 1

From the Service Manual Vol 5 of 5

1. Remove the Cluster Bezel by applying parking brake, move shift lever (automatic) all the way down, tilt the steering wheel to full down position, Gently pull rearward on the corners of the bezel from the instrument panel assembly, remove bezel

2. Remove 3 screws

3. Pull out slightly to gain access to connectors

4. Disconnect the wire connectors

5. Disconnect coaxial cable from radio (Non-Digital)

6. Remove radio

Install is just opposite from removal

screw tighten to 14 lb in, don't use paint, lube, corrosion inhibitors, locking compound

Make sure all clips are in place on the bezel

Answer 2

depending on what year you have the screws are in different places for the dash but after you remove the screws just gently pull it off, the pins will release and the screws holding the stereo in place will be visible.

Answer 3

First start by removing the plastic trim ring that surrounds the radio and climate controls. the whole piece pops off, use some caution as the 12v plugs and traction control wiring is just long enough to let the piece rest on the floor without disconnecting them. Next you will need to remove the six 8mm bolts four of which secure the radio to the dash and the other two hold in the climate controls. gently lift the climate controls up and then slide them out towards you and they should come easy. now just slide out the factory radio disconnect the wiring harness and antenna and your done!

Answer 4

I took out the three bolts and it still won't move is there anything else I need to do