There is a site that shows how to remove the rear bumper in an Accord but it is NOT the 2002 but the 2003 model. I don't know how much different this would be but it might give soe insight. The link is www.cardomain.com/ride/650229/3
To install a rear bumper on a 1999 Honda Accord place all the mount clips in the appropriate brackets. Clip on the bumper then proceed to screws in the hardware in the correct mounting locations.
I need to replace the bumper cover on a Honda accord 98 EX 4door. is there a site where the screws and pags are?
remove the bumper, you will then see the bracket that holds the bottom of the light to the car. the rest is pretty self explanitory once the bumper cover is off
behind the bumper
remove the square pop-out on the bumper and there is a screw on the outside of the light
A 2004 Honda rear bumper cover can be made to fit a 2007 Honda Accord. However, the amount of helper parts to make this fit happen will cost more in the end than it would to have just bought the bumper outright.
the car with an H in the middle of the hood and/or trunk and says accord above the rear bumper
how do i remove the fan/blower motor on a 2001 Honda Accord LX?
1994 Honda accord ex remove rear rotor
Not 100% but it should fit yes the accord 5 gen was from 94-97
The 1991 Honda Civic front bumper is secured by eight retaining bolts. Remove the retaining bolts. The bumper will come off.
How do you remove an air condition belt on a 1994 Honda Accord EX?
To professionally repair a bumper on a 2003 Honda Accord it will cost you anywhere from $200.00 to $600.00. However, doing it yourself can definitely save some money.
The rear bumper on a Honda Civic is held on using several mounting screws. After remove each screw the bumper will be held on with mounting clips. The bumper can be gently pulled off.
No, it will not even come close to fitting.
Possibly, as they are the same generaion. Compare them yourself and you should be able to tell if they are the same.
No. It's bolted on. If there are some clips that get broken accidentally in the process, these are cheap to replace.
remove plastic rivets and bolts holding bumper within fender well, between lights near hood latch, and bottom of bumber, be careful taking bumper off to prevent cracking. exact opposite for installing bumper
It is about $300 to $350 in Flushing NY
Coupe? There are little screws on the underside that you'll have to reach under and remove with a small, short screwdriver. Sedan? I believe the grille is part of the bumper.
How do you remove a water tube from a Honda accord 91 ex