Easiest way is to remove engine fan remove fan shroud,radiator,condensor and grille then remove intake manifold, valve covers, water pump and brackets that may be in the way. Remove timing cover, the remove all rocker arms and push rods and lifter. Remove timing chain and sprockets the slide cam out and reverse process.
Be sure to put engine at #1 to ease setting up the cam and removing the distributor.
Yes you do. You have to take the distributor shaft out of the distributor to Remove the pick-up coil / stator.
Yes, They will bolt right up.
YES they are the same.
no that is not possibale because of the lenght of the shaft
400 has a longer stroke
how do u remove the radio from 1996 f 350 ford truck
remove dist.cap.unplug wires and hoses mark rotor where it is pointing...remove holddown bolt remove dist.
where can i find a vaccum diagram for a 1985 Chevy truck with a 350 small block
yes you might have to change your exhaust manifold
That would be a long shaft water pump.
If it is a truck, Then yes it does.
behind the glove box on passenger side...you will have to remove glove box to get to it
Show you the automatic transmission, passing gear linkage for a 79 Chevy 350 eng. truck
Truck or car truck 210 hp
That 87 truck already has a carburetor on it.
No difference in the engine. It is all in the trans and the rearend
there are several different varieties of the turbo 350 trans. some were short shaft some were long shaft. your best bet is to actually measure it.
Yes it will, Thay are the same.
YES, That would be a direct swop.
There were turbo 350's with both a short and long tail shaft that fit a chevy. Long shaft were common from 71-76.
How do you remove power steering pulley on a 1990 ck truck
No it will not. The center shaft in the 4x4 transmissions are longer so the transfur case will fit on it. You can take the center shaft out of the 2-wheel trans and install it in the 4x4 trans. and it will work. But that requires taking both transmissions compleatly apart. Sorry but what you want to do will not work.