how long has it been in there? what kind of animal? has the car been run since then?
Remove the inside door panel of your 1988 Lincoln Town Car. Remove the wiring harness from your window motor. Remove the window motor retaining screws. Reverse the process to install a new window motor.
To remove a dead mouse from the car air conditioner fan, it will be necessary to remove all the air ducts by the fan or blower. Removing the blower might allow access to the dead mouse without tearing all of the duct work out.
Generally, blocking a sidewalk with a motor vehicle is against the law. You should call the police and ask them to remove the vehicle.
What kind of car/truck? I am changing the motor in a 99 cavalier. I have the door panel off and now I am trying to remove the motor.
You remove the axle nuts and a ball joint to remove the CV axles. Then you remove the shifter linkage. Remove the starter and all the other stuff that's hooked to the tranny. Then you place a jack under the engine. Remove all the bolts holding the tranny and the engine together. Now unhook a couple motor mounts, raise the car up, drop the engine down and slide the tranny out. You do not have to remove the motor to take the engine out. You simply need to take all the bolts out of the tranny that are going into the motor and then remove it from the motor with the motor in the car.
Most likely cause is a corroded set of battery connections. remove, clean and re-install.
can the heads be remove and install in car with out removing motor Yes. Im doing that now. Be careful with pipe at the back. They expensive to replace.
crawl under the car an remove it
Take the death certificate, car registration, and car title to the department of motor vehicles in the city/ town of the state you live.
remove hood supports so hood can open about 90 degrees. support with stick or like me, bungee it to garage door runners. remove wipers arms and link to wiper motor, all screws on cawling, weather strip lifts off. remove cawl cover(remove washer hose), lift lid off motor box (3 tabs on side). remove 3 screws holing motor in, unplug motor.
If the reservoir is blocking the way, then it will have to be removed.
It's inside the car on the passenger side. You'll need to remove a hush panel to gain access to the motor.