We need you to answer this question!
If you know the answer to this question, please register to join our limited beta program and start the conversation right now!
Asked in Cars & Vehicles, DIY Projects
How do you remove the distributor on an EA falcon?
To remove the distributor on an EA Falcon, first remove the distributor cap. Use an extension bar to reach and remove the small lug that holds the distributor. ...
Do you have to remove the distributor to replace the ignition coil on 1990 Toyota Camry 4 cylinder?
No. The coil is the piece at the other end of the wire that comes out of the center of the distributor cap. ...
Asked in Ford Bronco, Ford Bronco XLT, Ford F-150
How do you remove ignition module 1990 ford bronco?
on the distributor. Remove 6 wire connector, loosen distributor, turn to gain access, 7/32 socket ground down to fit in hole. remove screws pull down. difficult to get to back screw ...
How do you remove heater blower motor from 1990 Mercury Topaz?
The blower is behind the glove box. Remove the glove box door, and there it is. Some small sockets will be in need. It will come out if you wiggle it around. ...
Why would a Ford Mercury Topaz have no spark?
Not knowing the year, its hard to say. But if you have a distributor, and have a coil like 1989 1990 or so, and have no spark to the plugs, or coming from the coil to the dist. Then look for the ignition module that is screwed to the lower section of the distributor, have to remove the dist. and mark everything for timing after, need very small socket to remove the module, make sure to use the heat jell, and...
How do you change the distributor on a Ford truck?
Rotate engine to TDC Intake Stroke Remove Distributor cap Remove vacuum line to vacuum advance if equipped Remove horsehoe type clamp on side of distributor Lift out distributor ...
Asked in Chevy Blazer, Chevy Blazer S-10
How do you take the distributor off of a 1991 blazer 350 5.7liter?
you remove the wires that are going to the distributor and look where the distributor meets the intake there is a little plate the rests against the distributor and it has a bolt in it remove that and pull distributor up and out and u have to remove wires that go to the plugs as well ...
Asked in Chevy 350
Do you have to remove the distributor to replace the stator in a 90 Chevy 350?
Yes you do. You have to take the distributor shaft out of the distributor to Remove the pick-up coil / stator. ...
How do you remove the distributor cap and rotor on a 1994 Nissan Sentra?
how do you remove a distributor rotor on a 92 Nissan sentra
Asked in Chevy Celebrity
How do you remove a distributor cap from a 1986 Chevrolet celebrity?
On the 2.8L V6 the distributor cap is held on with two screws. Unscrew the two screws and pull straight up on the distributor cap to remove it from the distributor. ...
Asked in GM and GMC
How do to remove a distribuitor on a 89 GMC Surburban?
Bring the #1 cylinder up to top dead center, remove the distributor cap, mark where the rotor is pointing on the distributor body, loosen or remove the distributor hold down and pull the distributor straight up. ...
Asked in Chevy Astro, Dodge Ram Van, GMC Safari
How do you replace the distributor cap on a 1996 Chevy Astro van?
Remove the center console/cupholder. Remove the interior doghouse. Remove distributor cap. ...
Asked in Ford, Chevy S-10, Chevy 350
How do you remove a distributor on a 1976 Ford 302?
Assuming you have set the engine to #1 TDC and marked the position of the distributor and the position of the rotor, remove the distributor hold-down clamp and it's bolt, then pull the distributor up and out. ...
Asked in Acura Integra
How do you remove the distributor rotor from a 1994 Acura Integra?
Remove the bolts that hold the distributor cap onto the distributor. Once this is off the rotor can be reached and replaced on a 1994 Acura Integra. ...