take the door panel off to expose speaker
remove the door panel
1.Remove the front door trim panel.Remove the speaker retaining bolts.Disconnect the electrical connector and remove the speaker from vehicle. Installation is the reverse.
Should be same as 2001 setup where you have to remove interior door skin to acess speakers, and the 2001 had 4"x6" ovals in doors.
6x9
You do not need to remove the door panel to change your speakers. Remove the speaker cover, by prying outward on the speaker cover retaining clips. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.
6 1/2 round
6.5 in the front and 4x6 in the back
Remove the screws that fasten the console to the floor, there are 2 in the rear cupholder, 1 in the front cup holder, and 2 near the shifter (where the console seperates). When all the screws are removed you can lift out the console (be careful to unplug speaker wires), turn over, and remove the speaker.
Remove the door speaker cover. The cover is held in place with two retaining screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker. Reverse the process to install the new speaker.
remove the screws usually behind the door handle, also remove the cover tabs on the door grab on the panel and then remove the speaker grill and remove the three or four screws around the speaker not the ones holding the speaker in place.
how do you change front brake pads on a 2001 kia optima
How do you remove rh front axle from transmission on 2001 chrysler concordeRead more: How_do_you_remove%20lh_front_axle_from_transmission_on_2001_chrysler_concorde_lxi