first of all you need to take of screws on the coner of the bumper and the inside then under the bumper once you have done that there are 4 screws that hold the headlight on the bottom of the light on the passanger side it is easy to take off but on the driver side you need to go under the car between the radiator then you must unplug the headlight and it comes out i just did for my 95 it should be the same for 97.
Begin by removing the wiring harness from the back of your headlight. Remove the headlight assembly retaining bolts. The headlight assembly will come out.
In order to remove the whole assembly, you have to remove the front bumper cover which will expose a bolt on the bottom of the assembly which has to be removed...along with the bolt on top of the radiator support beam on each headlight!
the sucker is welded on, you gotta remove the bumper and tail lights, and start drilling away at the welds
You must remove the front bumper to access the headlight.
Remove the front bumper cover.... there should be 3 mounting bolts to remove the headlight after the bumper is removed.
You'll have to remove 4 bolts on each headlight, 2 are located on the rear part of the housing close to the fender - one on top of the headlight and the fourth is on the bottom you'll need to push in the socket between the headlight and the front bumper....
Horns generally can not be repaired but replaced. On a 2001 Mitsubishi Eclipse the horn is located inside the front bumper. To replace it disconnect the mounting bolts and remove it. Replace with a new horn.
remove center consul, there it is
Yes
First, you'll need to remove the front bumper. To do this, take off the bolts underneath the front part of the bumper. Remove the bumper turn signals to access the two bolts per side that hold the bumper on the car. Support the bumper by putting something underneath it. Then get a stubby Phillips screwdriver and remove the two screws per side at the end of the bumper (in the wheel well). Bumper should come off. Remove the headlight assembly by diconnecting the headlight sockets, remove the 10mm bolts above each headlight assembly. Remove the 10mm bolts below the headlight assembly. Done.
Need to remove bumper
You First must remove the bumper that should have only nine clips, then remove the right headlight to get to the reservoir. this seems like a lot and it is, but the reservoir is under the headlight assembly and the only way to remove the headlight is to remove the bumper.