You have to put it in the overflow tank.
The horn relay on a 1991 Oldsmobile Cutlass Cierra is located on the passenger side firewall inside the engine compartment. It is just to the left of the blower motor assembly.
With money take it to someone who knows.
The 1991 Oldsmobile Cutlass cooling fan relay switch can be found attached to the right side of the radiator housing. The cooling fan relay switch should be labeled as such.
how do ypu change front turn signal bulb on Oldsmobile 1991 cutlass cierra
Nee more info cutlass supreme or cutlass ceira which engine 3.1-- 3.8-- 3.3-- ????? Oldsmobile cutlass ceira 3.3 liteer engine
100 foot pounds
my car turn over,but will nostart.
Where is the choke sensor on a 1991 Oldsmobile ciera 3.3L
If i am correct, you would have to open the trunk to look at the bottom of the rear speakers, and then once you have seen them, you should see a bracket that is holding the speakers. If I'm correct, you should have to remove the clip or bracket that holds the speaker up and then you should be able to pull down the speaker with ease.
Need to know what quad drivers are...
The most obvious thing to check when a 1991 Oldsmobile Cutlass Supreme won't start is to make sure that the vehicle has gas. You should also check the battery. If the car clicks when you try to start it, it is likely the alternator.
Try 1-800Radiator.com or 1-800-Radiator for information
about 4 in the trans, about 5 in the lines.
This probably has to be ordered from the dealership as it needs to be encoded, which is proprietary information.
Was there a 1984 Oldsmobile Cutlass Calais? I see them listed at 1988-1991. Assuming that you mean "wiper blade" (blade and frame) which are replaced often rather than "wiper arm" (piece from the spindle at the hood to the wiper blade) which are rarely ever replaced, ALL 1988-1991 Oldsmobile Cutlass Calais' have 3/16" Side Lock wiper arm attachments. See Sources and Related Links below.
its in back valve cover at fire wall i removed the plenum from the intake manifold to get at it.
Look under hood against firewall - should be a plate with paint codes
ACDelco PF-47. Purolator Classic L10111. Fram Extra Guard PH3387A.
Go in through the back of the light in the trunk. You might have to pull away the carpet in the trunk to ger at it. Then it just twists out.
Unless it has been converted to R134, the OEM refrigerant installed in 1991 was R12 Freon. I suggest you have it converted to R134 if it has not already been done.
The serpentine belt is broke or loose. Replace the belt
there are screws on the top and side of the light. They use torx screws. there are screws on the top and side of the light. They use torx screws.
What you need to do is open the trunk. Then you need to remove the liner in the back of the trunk closest to you then you can see the wires the twist out.