A person can remove the front license plate cover on a 1990 Corvette with a screwdriver. The plate can then be replaced with a custom plate or a state plate if required.
HOW IS BEST WAY TO REMOVE BULB ON THE GMC CANYON FOR LICENSE PLATE LAMP ?
Open trunk, plate fits through a slot--just push up from the outside front of plate
Rear license plate lights replacement require that you remove the entire frame with reverse lights. Remove the 3 cover bolts on the inside of trunk, remove license plate, remove the for bolts holding frame to tyrunk lid, slide unit down and out and you will have to twist the bulb sockets and remove the bulbs and install in reverse.
Remove 1. Bolts retaining license plate lamp to bumper. 2. Socket from license plate lamp. 3. License plate lamp. 4. Bulb from socket. Install or Connect 1. New bulb to socket. 2. Socket to license plate lamp. 3. License plate lamp. 4. Bolts to retain license plate lamp to bumper.
I have a 94 not sure if they are the same but behind the license plate was mine Good luck Answer Improvement (Sept 5. 2010) Remove 4 license plate screws and licence plate Remove 4 hex head screws that hold the license plate/backup light assembly Rotate the license plate/backup light assembly around 180 degrees so you can get to the light bulb holders Carefully turn bulb holders 1/4 and remove bulb holder Carefully remove old bulb and replace with new bulb (#194) Reverse these step to reassemble
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
It will be necessary to remove the front license plate and bracket. Remove license plate from bracket. Using a 3/16" drill bit, drill out the two pop rivets that hold the bracket to the bumper. This is from a a bull bar installation guide for a 2008 Ford Escape/2008 Mercury Mariner.
Changing the license plate bulb on a 2002 Lincoln LS is quite simple. You must first remove the license plate first. Then unscrew the old bulbs and screw in your new ones.
To change the license plate light on a 1998 Chevy Cavalier, reach up under the bumper and remove the bulb over the license plate. Then put a new bulb in the socket. The bulb can also be accessed by removing the lens on the outside, but there are screws to remove first.
== # Remove screws attaching license plate lamp to rear bumper # Remove lamp from bumper. # Remove bulb socket from lamp. # Pull bulb from socket. == # Install bulb into socket. # Install bulb socket into lamp. # Place lamp in position. # Install screws attaching license plate lamp to rear bumper.
Because this bulb is mounted vertically, it can be tricky. The recommended method is to remove the license plate and open the trunk lid.