answersLogoWhite

0


Best Answer
Copy

THERES USUALLY ONE BOLT COMING FROM THE TRANSMISSION SIDE, AND ONE GOING TOWARD THE TRANSMISSION ON THE STARTER SIDE, THEN THERES A SIGNAL WIRE, AND A POWER WIRE THAT NEED TO BE REMOVED. pRETTY BASIC AFTER YOU FIND THE BOLT FROM THE TRANNY SIDE

User Avatar

Wiki User

โˆ™ 2012-02-16 18:33:57
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you remove a starter from a 1987 Nissan Sentra?
Write your answer...
Submit

Related Questions

How much did a 1987 Nissan Sentra cost brand new in 1987?

7000


What are the release dates for Motorweek - 1987 Nissan Sentra 26-5?

Motorweek - 1987 Nissan Sentra 26-5 was released on: USA: 6 October 2006


How do you install a starter in a 1987 Nissan Maxima?

Remove the negative battery cable then follow the posative cable and find the starter. remove the wires and mounting bolts and work the starter out. Sometimes the bolts are hard to get to.


What is the firing order for a 1987 Nissan Sentra?

http://autorepair.about.com/od/enginefiringorders1/ Specifically, for the 1987 Nissan Sentra: http://autorepair.about.com/library/firing_orders/bl-nissan-firing-87.htm The firing order is 1-3-4-2


What are the release dates for Motorweek - 1987 Nissan Sentra SE-R - 26.51?

Motorweek - 1987 Nissan Sentra SE-R - 26.51 was released on: USA: 24 August 2007


What are the release dates for Motorweek - 1987 Nissan Sentra SE-R 26-51?

Motorweek - 1987 Nissan Sentra SE-R 26-51 was released on: USA: 24 August 2007


Where is the PCV valve located in a 1987 Nissan Sentra?

You can find the PCV valve for your 1987 Nissan on top of the engine. The PCV valve will be near the air filter housing.


Why would a 1987 Nissan Sentra not start but after push starting is fine for a while?

Start with checking the battery terminals for corrosion, then the wires going to the starter. Be sure everything is clean and tight. Also have the battery checked


How do you change the starter on 1987 blazer s-10 with manual trans?

Remove the positive battery cable from your 1987 Chevrolet Blazer battery. Remove the starter cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.


What is the spark plug gap on a 1987 Nissan Sentra Wagon?

.044 will work out just right for you. good luck


How do you replace the starter on a 1987 Nissan 200SX?

cant see bolt on other side off starter, how to replace it ?


Where is the starter located on 1987 Nissan pickup?

above the oil filter,to the left.


Torque specs for a cylinder head on a 1987 Nissan Sentra sohc?

The 1987 Nissan cylinder had bolt torque specification is 140 pounds. The cylinder head bolts should be torqued in 45 pound intervals.


Where is the reset button panel located on a 1987 Nissan Sentra?

It is on the passenger side floorboard behind the kick plate( which will be on the right)


How do you locate remove and install the starter on a 1987 Nissan Stanza?

starter is located on drivers side below intake manifod very hard to see it, easier to see from underneath it attaches with one bolt from bell hsg. side and lne from starter side.


1987 Nissan truck 4x4 where is the starter located?

above the oil filter ,to the left.


How do you remove a starter from a 1987 Chevy 350 small block?

remove grn from bat. remove bat cable from starter solinoid. remove brn wire from starter solinoid. remove two 3/8bolts from starter to block. tilt nose of starter up and lower. this is most common.


How do you replace the starter on a 1987 Ford E-150 Econoline Van?

Disconnect the - battery cable Raise and support vehicle Remove wires at top of starter Remove starter mounting bolts Remove starter


What could cause your 1987 Nissan Sentra to pull to the right and make a popping sound when you make right turns?

cv joint


How do you remove and install a starter on a 1987 Nissan Stanza?

Oh yeah dude, easy. Remove the frame rails on the bottom of the car right under the starter (below the throttle body) then take off passenger side wheel, remove that from the transaxel (some working space) then remove the engine mount that is in your way. Just rip out the starter, take it to a parts shop, get a new starter and your core back =) and stick the new one in! Hope that heps!


How do you change a starter in an 1987 88 delta Oldsmobile?

disconnect the battery, then the wires from the starter. Then remove the bolts holding the starter to the engine.


How do you replace a starter for a 1987 Chevy S10?

Remove one battery post connection. Remove wires from starter and be sure you know where they go back. Remove large bolts from starter and put the new one back in.


How do you remove the starter on 1987 Harley Davidson?

Disconnect battery negative terminal, drain primary chaincase, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.


How do you replace the heater core in a 1987 Nissan pickup?

Remove the water from your 1987 Nissan pickup truck cooling system. Remove the water supply hose. Remove the water return hose. Remove the heater core retaining bolts. Reverse the process to install your new heater core.


How do you replace the water pump on a 1987 Nissan Stanza?

Drain the water from your 1987 Nissan Stanza. Remove the water return hose from the water pump. Remove the water pump retaining bolts. Reverse the process to install the new water pump.