How do you remove starter on a Geo Tracker?

Answer 1

First, find the negative cable on the battery and remove it. Locate the positive cable, then do the same thing. Now, the battery tray bolts need to removed for the car's body. You should be able to remove the tray without resistance. A creeper that moves on wheels is required to hold the motor whenÊtakingÊout the bolts that hold the starter to the block. Place each item back in the reverse order. Make sure the attach the positive cable first on the battery.

Answer 2

Begin by removing the positive cable from your 1991 Pontiac Grand Am battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

Answer 3

The starter on a 2004 Mitsubishi Gallant is removed by disconnecting the battery, removing the protective shroud, and unbolting the starter. The wires are then disconnected and the starter pulled from the engine.

Answer 4

The starter is on the below right side of black at fly wheel. Pull the negative terminal on the batter FIRST. Then the Positive. term. (when done, put NEG lug on LAST) Then remove the manifold (intake ) brace. Remove the 3 wires to solenoid. Remove the 2 bolts (nuts) at starter. Do not fail to put the ground wire back on starter as you found it. top bolt.

Answer 5

Note:It may be necessary to remove the exhaust pipe(s) or frame crossmember to gain access to the starter.In extreme cases it may be necessary to unbolt the mounts and raise the engine slightly to get starter out

• Disconnect the negative battery cable.If the vehicle is equipped with a delco loc 2 or theftlock audio system make sure to have the activation code before disconnecting the battery.
• Raise the front of the car and support it securely on jackstands.Apply the parking brake and block the rear wheels.
• On 2.2L engines with manual transaxle remove the brace between the engine and the transaxle.On 2.3L and 2.4L OHC engines remove the air intake ducts to gain access to the top starter motor bolt locatedon the transaxle
• Remove the mounting bolts and detach the starter.Note the location of the spacer shims they must be reinstalled in the same position (if used)
• Working under the car clearly label then disconnect the wires from the terminals on the starter motor and solenoid

Answer 6

Remove the cable wires from the starter. Remove the retaining bolts. The starter should come off. You may need to tap on the starter with a hammer to loosen it.