answersLogoWhite
Chevy Blazer

How do you remove a starter out of a 1985 Chevy Blazer?

232425

Top Answer
User Avatar
Wiki User
2015-07-15 21:15:12
2015-07-15 21:15:12

Take the positive cable off the battery, then you have to remove the inspection shield on the transmission and then take the two bolts out of the starter

1

Related Questions

User Avatar

The overall length of a 1985 Chevy Blazer is 4,712 mm or 185.5 inches. Its curb weight is around 2075 kg.

User Avatar

disconnect battery-crawl underneath,unbolt existing starter,undo related wiring-reverse with new unit,reconnect battery, have a beer

User Avatar

Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter

User Avatar

To change the starter on a 1985 Chevy Celebrity: 1. Disconnect the battery ground. Use gloves to avoid getting battery acid on your skin. 2. Raise the car and put on stands. Be sure the parking brake is on. 3. Remove the wires to the starter solenoid. Take note of their routing . 4. Some starters have a brace at the front of the starter, remove it if present. 5. Using an appropriate socket remove the two bolts that hold the starter in place. There may be shims on the starter, if present save them for re use. The starter should now pull forward and then lower it from the engine. Replacement is the reverse of the above.

User Avatar

check your regulator. it maybe over charging your battery

User Avatar

The 1985 Chevrolet S10 Blazer has a curb weight of 4,462 pounds. The standard fuel tank capacity for this vehicle is 24.83 gallons.

User Avatar

Its mounted on pulley system on t besi he front of the engine opposite the alternater for k5 blazer 1985 an in the same place from 79 to 87 years

User Avatar

Disconnect the - battery terminal Raise and support vehicle if neeeded Disconnect wiring from starter Remove mounting bolts Remove starter

User Avatar

UNDERNEATH THE ENGINE ON THE PASSENGER SIDE NEXT TO THE OILPAN.

User Avatar

I have a Chevy 350 from a 1985 blazer in my 1990 wrangler. So yes it is. I also have the transmission and transfer case from it in my jeep to.

User Avatar

The curb weight of the 1985 Chevrolet Blazer is listed as 3760 pounds. The curb weight does not include any fluids or accessories.

User Avatar

what is the wheel base for 1985 s10 blazer

User Avatar

It already has throttle body fuel injection.

User Avatar

The 1985 Chevrolet have blazer tail light fuse can be found in the fuse box. The fuse box is located beneath the drivers side dashboard.

User Avatar

Disconnect the battery. The vehicle will probably have to be raised to reach the starter. The starter has two or three bolts holding it in, and wiring attached. Remove the wires remembering where to put them back. Remove the bolts and pull starter out.

User Avatar

over charging or bad bearings its about to let you stranded change it

User Avatar

Up front, under the power steering pump, not easy to get to.

User Avatar

inside driver frame rail under driver seat

User Avatar

Remove the retaining ring at the top of your 1985 Chevy ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.