Apply WD-40 or any type of penetrating spray and let it work for at least 20 minutes. If the bolt is strong you can simply place a properly sized socket wrench over the bolt and use a box-end wrench (one with a closed-end/doughnut-hole) as leverage on the handle. If you're doing it correctly the 2-tools will resemble a wide V. Works like a charm.
The bolt is stuck and can't seem to come off.
The Rotor has a small bolt that holds the Rotor on the shaft. Did you Loosen this bolt?
prie the blocker for the release line rate off, then just unscrew the bolt
A few light taps on the end of the bolt, with a hammer will usually do the trick.
Heat the stuck bolt until it's red hot, let it cool completely, turn it out with proper size tool.
It takes a special puller to remove the balancer. Advance auto parts stores will loan it to you. It is called a harmonic balancer puller.
Use a screw extractor or easy out.
it is stuck use a brass punch so you do not damage threads hit it a couple times should break free.
Remove the firing pin from the rear and the locking bolt will side out the side of the bolt
Most of the time it breaks off and you will need to drill it out and replace screew.
Without seeing your situation. If you are unable to loosen a bolt then use a longer wrench to put more torque on the bolt head. If the bolt is loose but stuck in the hole use a drift punch and a hammer to tap it out.
To remove the stuck spark plugs, you can break them loose and then start to get them tighter as you rotate them out. The ratchet wrench can also be used to remove the stuck spark plugs.
What bolt and where is it stuck ? If it is the bolt holding the blade on, generally you hold the blade and loosen it. If this isn't possible for some reason, I would put a wrench on the head of the bolt, a 6 sided box end wrench instead of a 12 point. Hold the wrench on the head so it doesn't pop off and smack the end of the wrench down with a hammer. If you have access to one, an impact driver should do it. If it is some bolt on the saw itself, it would depend on where it was and what you can use to take it out.
remove shifter boot/ 4 screws to floor board remove nut from cross bolt install nut on opposite side of cross bolt and tighten nut cross bolt is tapered, this will remove cross bolt
How do i remove a stuck Cd from my 2005 Toyota Highlander? The CDs will not eject.
how to remove key stuck in ignition switch in Chevy colbalt
First remove the screw opposite the bolt. Operate the bolt as if you were cocking the gun, pull the trigger and it will slide out.
Take bolt apart take bolt head and clamp in a drill press use a 3/32 drill bit to drill it out shouldn't have to drill all the way out . Numrichs brownells and midway usa have the ejector the spring and the retaining pin
My 2004 alternator on the V6 has three fasteners that have to be removed to remove the alternator. The pivot bolt,the stay bolt and the adjustment bolt. Once you loosen the pivot bolt and the stay bolt, the adjustment bolt can be turned back to loosen the belt enough to remove the other bolts for alternator removal.
Open the bolt, hold the trigger back, pull the bolt out
how do you remove a cd that is stuck in cd player when i push the eject button it makes a clicking noise
How do I remove cassette tape stuck in my 1998 Volkswagon beetle