No crank sensor. Only has the distributor pick up plate.
Remove the inside door panel of your 1997 Chevy Lumina. Remove the linkage to the window crank. Remove the window crank retaining bolts. Reverse the process to install the new window crank.
You will need to remove the inside door panel of your 1977 Chevrolet blazer. Remove the window crank linkage. Remove the window crank retaining bolts. Reverse the process to install the new window crank.
Remove the inside door panel. Remove the Allen screw from the window crank linkage. The window crank handles should come off.
Pry the screwdriver between the door panel and the window crank base. Remove the metal clip slowly and carefully. Pull the base of crank to remove it.
To replace the window crank handle on the 1993 Geo Prism, first remove the interior door panel. Then, access the screw that holds the window crank in place and remove it. You can then remove the handle itself.
You need to remove the window hand crank with a window hand crank removal tool.
Pull out the U-clip located on the base of the window crank.
you can buy a window crank removal tool at an autoparts store that pulls the little pin off to remove it.
You can remove the window crank handle by just using a simple shop rag. How you do this you slide the rag(unfolded) between the door panel and window crank and rotate around the window crank until you snag the clip that is retain the window crank. The clip is a simple wire clip shaped like a "C" To reinstall you place the clip back in the groove on window crank and press back on the window regualtor shaft
To remove the window crank on the 1992 Toyota Paseo, first pry off the interior door panel. Then, access the screw that holds the crank in place. Remove the screw and the handle will come loose.
You need a crank removal tool
Remove inside door handle and window crank handle, remove inside door panel, remove vent window and channel assembly, remove window.
The cam position sensor is inside the distributor, under the cap and rotor. There isn't a crank sensor.
It is held in place by a horseshoe shaped clip. the clip is removed by reaching behind the handle with a small pick and pulling the clip out.
It doesn't have a crank sensor. It only has a distributor pick up plate (cam sensor).
Their is a special tool to remove manual crank window cranks and it will work for almost any car. You can pick one up at auto zone
push in on the door pannel by the crank and remove the snap ring behind the pivit point
Your local auto parts store can sell you a very inexpensive tool to remove the clip that holds in the window crank handle. It should be under $10.
You have to remove the inside panel, where the window crank is, or would be.
You have to have a window crank remover, this tool looks like a U on a stick, and you slide this tool in between the the crank and the door panel and trip the lock pin, then the crank will pull off.
They sell a window crank removal tool to open the cotter in and slide off the winow crank handle. Slide the tool under the window handle and push the cotter pin back, off comes the handle
you have to remove window crank and door handel first
You need to get a window crank removal tool from an auto parts store. Simple pressed steel tool for less and $5.
Your local auto parts store will sell you a very inexpensive tool to remove the "C" clip behind the crank handle.