pull the dash apart. behind the speedometer you will see the cable. it connects to the transmission.
Remove the dashboard cover. Remove the retaining ring, from the speedometer. Remove the speedometer cable from the back of the speedometer. Reverse the process to install the new speedometer.
Remove the dash panel cover. Remove the speedometer retaining ring. Remove the cable from the back of the speedometer. Reverse the process to install the new speedometer.
HOW DO YOU REMOVE AND INSTALL A SPEEDOMETER SENSOR IN A 2001 FOR ESCORT ZX2,AUTO.
Remove cables from battery Remove + cable from the starter solenoid Remove the - battery cable from engine ground install new cables using the same routings as original
Remove speedometer head to unscrew and remove cable Remove cable from transmission Re-Install new cable using same routing as original
Open the screw of the speedometer panel. Make sure it's not connected to the dash. Once removed, remove 4-6 screws that hold the speedomeer to the frame of the dash. Then remove the cables from the speedometer. Once loose, go underneath the steering wheel and disconnect the wire from the computer harness. Hope this helps :->
The most common reason for a speedometer to fail is a broken speedometer cable. Loosen the nuts on each end of the speedometer cable. Remove the speedometer cable retaining clips. Reverse the process to install the new speedometer cable.
Speedometer cables can dry out over time. Remove the cable from the back of the speedometer, and lube the cable with graphite. This should fix the issue.
First, take the battery cables off then remove the battery hold down then remove the battery. Reverse order to install. Be sure to clean the cables.
Remove speedometer head Disconnect old cable Follow original routing for new cable Disconnect fitting at side of transmission and remove cable - replace with new
Remove the positive cable from your 1995 Nissan Pathfinder battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
To replace the battery cables on a 1999 Mercury Mountaineer, loosen the connectors at the terminals. After this, remove the other end of the cables and install new ones.