The 1994 Honda Camry dashboard is held in place by 12 retaining clips. Pry outward on each retaining clip. The dashboard will come off in three pieces. Reverse the process to install the new dashboard.
To replace the check engine light bulb, you will need to remove the dashboard. Once you have removed the dashboard, the bulb for the light will be exposed and can be changed.
Answering "How do you replace the water pump on a 1994 Toyota Camry?"
The 1994 Toyota Camry emergency brake light switch can be found beneath the drivers side dashboard. The emergency brake light switch will be beneath the far left hand side of the dashboard.
Unless there is an access panel above the fuel pump, you must remove the fuel tank.
you have to take out the whole dashboard
To change spark plugs on a 1994 Toyota Camry, remove the black shafts. The spark plugs are down the four holes. Use a socket set with extension to reach the spark plugs. Replace old spark plugs with new ones.
Answering "How do you remove and replace the radiator in a 1994 ford F-150?"
Fuse, loose connection, or the light switch. how do you remove the dashboard on a 94 mercury grand marque?
The 1994 Chevrolet Blazer S-10 dashboard is held in place with eight retaining bolts and eight retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
Replace it with a know good one, if that fixes your problem then its the igniter.
Try this link: http://wiki.answers.com/Q/How_do_you_replace_the_headlight_bulb_located_on_a_1994_Toyota_Camry
Use a 14mm wrench to unscrew the bolt at the bottom of the oil pan.
Behind the right side of glove box, you have to remove kick panel on bottom a dashboard and flip glove box out to view and replace.
The body styles, internal and external trim and features were compatible, so the dashboard should fit.
It has a timing belt. Replace every 60,000 miles.
whats the weight of a 1994 Toyota Camry sedan?
where is the location of the diagnostic connector to 1994 camry?
You are looking at bill of 1-3K depending on damage.
The 1994 Toyota Camry came with standard 15 inch rims. The 1994 Toyota Camry offered an option for 16 inch rims.
To change a thermostat on a 1994 Toyota Camry V6, drain the radiator partially. Remove the upper hose assembly, unbolt the thermostat, and put the new one in place. Refill the radiator completely.
where is the gas filter in a Toyota Camry 1994?
Remove the passenger side wheel well liner and it's to your left, remove lines and replace.
No, it will not work.
There is a small slot on the hard plastic cover near the end of the dome light you will need a small flat head screw driver insert the screw driver in that slot use a back and forth motion to remove it.
NO! All you have to do is remove the exhaust downpipe and cross member that bolts up to the frame, then you have access to the oil pan.