The pump is in front of the rear tire on the drivers side just underneath the car. Jack it up and theres a cover that you must remove to get to it, and then a couple of nuts just above the pump to get it down, i just took mine down to check out the connections because i am having trouble with it also. Just don't forget to unhook the negative battery term. before u get started. Mine still wont start sometimes so you may need a diagnostic
You have to unscrew the center console and work your way up.
On a 1989 Acura Integra hatch back the brake lights are reached through the hatch itself. The brake lights housing are on the rear of the vehicle. Unplug the bulbs and replace them.
The wattage of your stock stereo in your 1989 Acura Integra is 75 watts. There was anÊoption for a larger stereo output of up to 200 watts.
Ignition timing is set on a 1989 Acura Integra by setting the distributor to the appropriate angle. When set at the factory recommended angle the car will turn over with no problems.
In order to replace a clutch on 1989 Acura Legend, you would have to remove the old one. You will do this by removing the jam nut that holds the pedal and disconnecting it from the throttle cable and replace it with a new one.Ê
8lts i think
The speed sensor on a 1989 Acura Integra is located on the transmission. It is a small unit with a two-wire clip which connects to the main engine harness of the vehicle.
there was no 1989 vigor..acura
its on the fuse box door. if you lost the door maybe you can get one at a junkyard or your friendly acura dealer might help
How do I put a alternotor belt on a 1991 Acura Legend
If it is the original ignition, you should be able to get a key from the dealer with the V.I.N. The number on the dash.
follow the bottom hose on the radiator to where it connects to the engine. Inside that connector is the where the thermostat goes. make sure you use some RTV gasket sealer for reassembly.
Follow the upper rad hose from the rad to engine and it is in a housing on the engine.
Try MOTORLIT.COM You can find the wiring diagram you need at autozone.com. that is where I go.
well unless you are certified to work on automotive a/c systems you can't even buy freon
with modification and skill with fiberglass, yes. but if you are asking this question, you wouldn't be able to do it yourself.
The firing order for a 1989 acura integra LS is 4-2-1-3 on distributor cap. That is clockwise(cw) with 4 @ the 12:00 position. With 4 being last cylinder on the driver's side. Hayne's auto repair was very helpful in finding this and actually had a picture of it in chapter with a diagram of the whole engine compartment.
UNDER HOOD, DRIVER SIDE, FRONT ENGINE AREA, MOUNTED ON BOTTOM OF RADIATOR
basically just remove the bolts holding it up, disconnect the harness, remove and replace!
How do you install an after market stereo in a 1989 acura legend?
you suck it up
access to the pump is behind the back seat inside the trunk. Disconnect pos.(+) cable; then remove about 6+ bolts (oval cover), remove the electrical connections (plug), remove about 6+ bolts (round pump cover), then remove the pump by pulling traight up, watch for the clearance. Hope it help.
how many oil quarts do you put in 1989 acura legend when changing oil