Usually you are replacing due to the top bolt snapping off from stress over time. The best thing to do is purchase a new sway bar link from Auto-zone for ~$25.00 and replace.
Not too hard, bottom bolt has hex key-way on end of bolt to hold so that you can remove nut. If not hacksaw off and replace accordingly. You do not have to take off tire if top bolt is broken, you should be able to get under vehicle and work freely. Not a hard job for home mechanic...you can save $200 easily by doing it in one afternoon. Good luck!
how do remove the tailgate's window motor on a toyota 4runner 1997 ?
To replace the rear bulb in a Toyota 4Runner remove the plastic covers located in the trunk. Taking off the plastic covers will reveal the taillight housing and bulbs. Replace the bulbs.
how do I remove the climate control from a 1999 toyota 4runner
The starter on a 1998 Toyota 4runner is held located on the transmission housing. The starter is held on by 2 bolts which mount it directly it the engine. Remove the two bolts to replace the starter.
Have to remove the door, then remove pins and bushings
remove the 10mm bolt and remove it.disconnect plug at other end.
Remove the negative battery cable for 6 minutes and then replace.
To remove a cigarette lighter from a Toyota 4Runner, pull the lighter straight towards you. Pull gently until it becomes free.
buy a new bumper, remove the old one, and attach the new bumper
take the bolts out
remove the seat replace the wire(s) that engage the locking slider replace the slide bearing IAEFs, replace the seat
To replace radius arm bushings on a Mercedes A class, remove the 1 1/8 nut at the end of the radius arm. Cut the rivets out and remove the 4 bolts holding the hanger on. Remove the hanger and replace the bushings and bolt it back together.
With great difficulty
They are small lights that you can replace by just counterclockwise screw it on the back of the light. You can just get to the left one but have to remove the air flow intake to get to the right one.
Remove the rear wheel from the axle. Remove the brake pads and hardware. Remove the axle end cap. Remove the bearing. Reverse the process to install the new bearing.
Remove the nuts! They are on the lower metal frame the seat
Remove the battery clamp and the washer bottle. Then you can move the battery a bit and get your hand in to get to the lamp holder. Louie
thats a good question there is not much room there
Requires a hydraulic press to remove and install.
Here is a web site that I saw that will help you on removing and replacing the starter on a 1999 Toyota 4Runner: http://www.4crawler.com/4x4/CheapTricks/Starter.shtml
Removal is relatively straight forward, it is easier to see with pictures then explain in text. Please check out my bio page for info on how to remove and service the clock.
How to replace a headlight on a toyota hiace van
you have look for the dashboard unions behind the thermostat control under the compartment
put a jack under front to relive tension and remove the two frame mounted bushings first then remove end links check all bushings and replace as needed i suggest using polyurathan bushings made by energy suspention