First you are going to remove the passenger side kick panel then the rocker plastic piece. from there you need to remove the glove box. open te glove box remove the 3 skrews where the striker is the there are two 10mm hex head bolts that need removal. then remove glove box assembly and now you have full access to the blower motor.
The 2006 Toyota Corolla blower motor is located behind the glovebox. To reach it the glovebox and passenger side dash must be removed. The blower is located next to the evaporator. Remove the mount screws and disconnect the wire harness from the blower to remove it. Replace with new unit.
The heater blower motor can be found beneath the passenger side dashboard. Remove the wiring harness from the back of the blower motor. Remove the blower motor retaining bolts. Reverse the process to install your new blower motor.
it is no suh a thing is fan belt on 2002 corolla
How i remove eveporator unit from toyota corolla 2002
how do you remove a center console on a 2001 toyota corolla
Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
Remove the wiring harness to the heater blower fan. Remove the retaining bolts. Remove the fan from the blower. Reverse the process to install the new heater blower fan.
They go in from the rear. remove the light assy.
Remove the heater control valve and replace it.
how do u remove cv axle driverside 1991 toyota corolla
If you have clearance just remove bolts
How do you remove the heater core on a 1997 Toyata Corolla?
Same as a 1999. Look for "remove starter on 1999 Corola" post I answered. Same as a 1999. Look for "remove starter on 1999 Corolla" post I answered.
Open the hood of the engine compartment to your 1994 Toyota Corolla. Remove the wiring harness from the headlight. Remove the headlight retraining bolts from the headlight assembly. Reverse the process to install the new headlight.
To replace a wiper motor on a 1994 Toyota Corolla, remove the rubber stopper that cover the hardware attached to the wiper arms. Then grab the wiper arm and jiggle it back and forth until it comes off. Remove the old one and slip the new one on.
which pully do i remove tension to remove the alternator?
The fuse box in a Toyota Corolla is located to the left of the steering wheel behind the coin tray. Pull up and out on the coin tray to remove it and replace it if blown.
To remove the back seat of a 1998 Toyota Corolla, you will need to remove the carpet to expose the bolts for the seat. Then, loosen the bolts by removing the nuts. You can then remove the seat.
how to install a blower motor for a 1994 Toyota pickup
you don't! remove bezel for gauges, remove four screws for gauge assembly, pull forward and tilt, replace the four bulbs.
The Toyota Corolla front bumper is held in place with eight retaining bolts. Remove the retaining bolts and the bumper will come off.
Replacing a starter on a 1989 Toyota Corolla is not very difficult to do. The wires will need to be disconnected from the old starter and labeled or taped. The starter is held in place by two bolts, unscrew the bolts and remove the old starter. Then replace with the new starter.
It screws right out