You will need to remove the door panel. There are two 10mm nuts you will need to remove, then disconnect the clip that holds the wire to the handle and push the clips holding the handle to the door outward being careful that to break the clips. Replace in the reverse.
how to replace a exterior front door handle on a 1999 toyota tacoma
how do I replace the seal on a 1990 Toyota 4x4 pick up, where the transfer case meets the exterior housing of the manual transmission?
On Engine, drivers side, under intake. Very tough to replace. Bad Toyota!
Here are directions for a camary. It is basically the same for the avalon.http://autorepair.about.com/library/weekly/aa092504b.htm
http://www.automotivetouchup.com/ The best sight I have found for factory colors...look for the code on your drivers door...or look on site by year, make and model....
A 2012 Toyota Prius exterior body width is 68.7"
I need to replace my outside handle on the drivers door. Toyota told me to go on line to see a diagram. But, where? It is a 2000 camry.
go to the website autorepair.about.com and they have the step-by-step instructions. good luck!
drivers side of enginge just below air filter contianer drivers side of engine just below air filter contianer
Replace the handle. You will need to remove the door panel to replace the handle. If you can't do this yourself take it to the dealer. They should charge you about 1.0 to 2.0 hours labor to do this, plus the part.
How do you remove and replace the motor for the drivers side power window in a 2000 Sienna
Replacing the door handle on a 1997 Toyota Camry is easy with the proper tools chief among which is your check book. Start by going to the nearest Toyota dealer. The rest will fall readily into place.