With a knife.
A sharp one.
How to remove Window Winder Handles from VZ Holden Commodore
Begin by removing the inside door panel. Remove the linkage from the window winder. Remove the window winder retaining bolts. The window winder will come off.
Between the window winder and door card there should be a plastic ring about 8mm wide. Push this ring away from the end of the window winder. The windes should now slide off
remove the tiny C clip from under the winder 1.25 1996 N. don't rip it off like I did.
Just pull it!
take it to safelite lol
The window winder is secured by a spring wire clip. Push the circular pad away from the winder handle and pull out the clip with a crochette hook or similar.
sounds like you window winder spring attached to your winder might be broken or the cogs on the winder have heaps of wear eg not touching sounds like you window winder spring attached to your winder might be broken or the cogs on the winder have heaps of wear eg not touching sounds like you window winder spring attached to your winder might be broken or the cogs on the winder have heaps of wear eg not touching sounds like you window winder spring attached to your winder might be broken or the cogs on the winder have heaps of wear eg not touching
purchase a 'door trim removal tool' from any auto shop and jam it under the retainer under the winder. this will allow the winder to be slid off its nipple.
http://forums.justcommodores.com.au/holden-commodore-how-s/5541-removing-vt-vx-door-trim.html
There is a really thin horseshoe shaped circlip behind the winder handle . Use a screwdriver to gently lever the winder away from the panel and then use a small thin screwdriver to try and unhook the circlip . A bit awkward but trust me it will come off .
there is a clip behind handly use a rag and run it around the hand and door panel and it will come off