0
remove nut in center of rotor
lift vehicle & separate ball joint
pull drivshaft out of rotor/hub assembly as you swing spindle out of the way
pull or pry out driveshaft
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you remove the drive shaft from a 1996 Geo Tracker?
First make drive shaft and yoke to insure tat they are replaced in the same location to maintain factory balance Remove small "U" bolts at yoke Pry drive shaft out of yoke Pull driveshaft off splined end
How do you remove the crank shaft pulley on 1996 Geo metro 1.3l?
How do I remove a pully from the drive shaft. The snap ring that holds pully on has been taken off.Itried a gear puller but it bends the pully.
Can you tow a 1996 4wd jeep with a tow dolly?
You will need to remove the drive shaft to tow a Jeep with a tow dolly.
Can you remove the drive shaft from the passenger side of 1996 Plymouth breeze to replace the output shaft seal without removing the strut?
Yes. You may also remove strut & steering knucle from car without separating them (if necessary) so you do not have to get an alignment.
How do you replace the fuel pump on 1996 probe?
Remove fuel tank for access
Mazda 323 1.8 executive 1996 you have snapped your drive shaft but cnt get your drivers side wheel off there is a centre nut on the wheel that you cnt remove?
?
Replacement of drive shaft on 1996 voyger?
The front axles do not have a removable shaft, you must replace axles completly.
What is the name of the part that the drive shaft enters in the back of the rear transmission on a 1996 gm suburban?
tail shaft
How do you change the fuel pump on a 1996 Pontiac trans am?
fuel pump is in gas tank you might have to drop your exhaust and or center support for drive shaft. to remove gas tank.
When was Amber Probe created?
Amber Probe was created in 1996.
WHAT is the best way to remove a front cv drive shaft from a 1996 jeep grande Cherokee?
I am sure there are proper tools on the market, but I had to do "emergency replacement" in my driveway. I used a pry bar and a hammer for removal - worked okay.
What is causing my 1996 Jeep Cherokee Front Drive Shaft Noise?
The universal joints in the front driveshaft may be going bad.
