First put the gear selector in low gear with vehicle parking brake on. Then pull the hard plastic part of the dash releasing the clips, also put the steering column in the lowest position. Once the dash is lose, lift it up out of the way. then release the clips one on each side of the ac unit control module. Then pull the wire harness off the switch, then the switch from the control module. Put back together in the reverse order.
it is under the glove compartment on the passenger side of the truck
Remove the wiring harness from the back of the blower motor. Remove the blower motor retaining screws. Remove the fan from the blower motor. Reverse the process to install the new blower motor.
possibly a blower motor. or switch
There is no inertia switch on the Chevy truck it runs from the ecm , oil pressure switch and relay.
Your truck has both. the resistor is between the switch & blower.thje resistor controls the blower speed
have the truck on, put the truck on neutral, then switch from 4wd to 2wd
In the switch assembly itself.
NO it will not.
how do you replace3 dimmer switch 1987 chevy silverado 4 x 4
First, take a socket wrench to remove the cover of the blower motor of a 1993 Chevy truck. Then pull the motor blower out and install a new one in its place. Lastly, screw the bolts of the blower motor cover back in.
behind the glove compartment, to the left
Remove the inside door panel from your 2003 Chevy Silverado pickup truck. Remove the wiring harness from your heated side mirror. Remove the mirror retaining bolts. Reverse the process to install the new mirror.
Could be,The blower speed switch or electrical plug at switch is burned out. The high speed blower relay is burned out. The blower motor is on its way out. The blower motor speed control resister is burned out, The cabin filter (if applicable) is very dirty.
remove glove box look at motor area unplug wires to blower motor, remove cover over motor, 5 screws to remove then take out motor and fan assm.
The Silverado is a full-size truck. The Colorado is a compact truck
put the parking brake in, then put the truck in 1st gear pop the dash cover off and then remove bolts from stereo.
Only for the high speed blower function. The lower speeds go thru the blower motor speed resister.
Need a new switch.
The 1989 Chevy Silverado pickup truck window wiper relay switch can be found on the firewall in the engine compartment. The relay switch will be on the passenger side of the firewall.
Check the blower motors ground and power in the truck and the blower motors resister......
The Chevy truck models included - Silverado, Hybrid Silverado, Silverado SS, Silverado with Z71 Off Road Package, and the Heavy Duty Silverado..
remove gas tank from truck, unscrew sending unit hold-down
You have to remove the transmission to get to the clutch slave cylinder on that truck. You can pull the engine if you want and get to it. YOUR CHOICE.
There is none on you truck. These models have a bad track record of fuel pump problems.I have replaced a few of them.
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.