Brake Pads and Rotors
Ford Ranger
Ford Expedition Eddie Bauer
Ford Ranger XLT

How do you remove front rotors on a 4 wheel drive Ford Ranger?


Top Answer
User Avatar
Wiki User
2006-01-16 00:42:00
2006-01-16 00:42:00

you have to pull the locking hubs off, lay a clean towel out and lay everything in the order you pull it out as there are several keepers and snap rings then you will have to use an axle nut socket and pull a big nut out, then the outer bearing. you will have to get new seals with your rotors and repack the bearings


Related Questions


how to remove front rotors on 2003 Nissan fronter 4 wheel drive pick up

how do you remove front rotors from a chev 2004 silveraldo crewcab not 4wd

First remove the right and left tires, and then proceed to remove the rotors. After you have replaced the rotors put them back on.

are 2wd and 4wd front brake rotors interchangeable on 1997 ranger 4L V6 XLT

pull off the front wheels. remove the calipers. remove the two screws that hold on the rotors. replace the rotors and reverse the procedure.

Front or rear, remove wheel, remove caliper, remove caliper bracket, remove rotor.

What should the thickness be on the front brake lining for ford ranger 2010

With the wheel off, remove the calipers, then the rotors just come off.

Remove the wheel, the calipers and the rotors, reverse procedure with new rotors.

Jack up and safely support front of vehicle. Remove front wheels. Remove front brake calipers and hang them with wire so not to damage brake hoses. Remove brake caliper brackets. Remove brake rotors. Rotors may need a little persuasion with a large hammer as they may be stuck/rusted in place. Reverse order to install rotors.

Does anyone know how to remove the chrome part of the front bumper on a Ford Ranger XLT

You will need to remove the front tire and wheels from your 2002 Jeep liberty. Remove the brake pads and break assembly. Tap the rotors with a hammer or mallet. The rotors will come off. Reverse the process to install the new rotors.

Jack the front end up of your 1994 Ford F2 50. Remove the tire and wheel. Remove the brake pads and assembly. Tap on the rotors until they are loose. The rotors will slide off. Reverse the process to install the new rotors.

Hello, Once you take the tires off and remove the calipers, the rotors come right off just like a front wheel drive car. There is no castle nuts or bearings to deal with like the older trucks had. Good luck .............

how to remove the door panels to re and re the speakesrs on a 2001 navigator ? how to remove the door panels to re and re the speakesrs on a 2001 navigator ?

The front wheels have abs sensors if applicable. The sensors would be mounted to the spindles not the rotors.

I recently replaced both rotors on my 97. You have to separate the rotor from the hub. They are actually 2 separate pieces.

remove the brake caliper and the rotors come right off

Remove brake caliper and caliper frame. Rotors are now free.

remove wheel ,remove calipers, remove centre bearing nut then slide off disc. be carefull not to drop the bearing in dirt

You will need to remove the tire and wheel. You can remove the brake pad and break assembly, by removing the brake spring and caliper. Loosen the rotors with a hammer. The rotors will slide off. Reverse the process to install the new rotors.

Remove the front tires, from your Pontiac Grand Prix. Remove the brakes and rotors. Unbolt the axle from the suspension. Remove the axle.

if you are driving and you go to stop, then that means that the front rotors are warped. if the front rotors are bad, you will feel a pulsation in pedal while applying brakes. change rotors on front.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.