GMC Suburban
Chevy Blazer S-10
Ford Escape XLT
Ford Ranger XLT

How do you remove front wheel drive on a 1993 suburban 4 wheel drive 5.7 liters V8 to change oil pump?

262728

Top Answer
User Avatar
Wiki User
Answered
2006-09-05 16:29:13
2006-09-05 16:29:13

You don't need to. Just unbolt the motor mounts and lift the motor up. Get under the truck & remove the oilpan bolts & remove the oilpan. remove & replace the oil pump. ake sure when you put the new sump screen on the new oilpumop, you measure the sump depth in the oilpan. Failure to adjust this correctly within 3/8 of an inch will result in low or no oil pressure.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


You will have to get a 4L60E 2-wheel drive transmission and put in it. You will also have to get a driveshaft made for it too. You will also have to remove the front driveshaft.
















how to remove a drive shaft on a fiat doblo


You must remove battery(under seat) then remove battery box. Remove nut from drive pully and remove pully, this now gives you the slack in belts to remove.



use a torch to melt out the plastic then remove the clips(on the inside) and remove as normal


Remove Distributor,remove drive gear,remove shaft,remove pickup coil.


To change the heater core on a 1999 Chevy 4-wheel drive, first remove the dashboard and drain the coolant. Unbolt the core from its mounts and remove the dash panel to be able to change the heater core.


Disconnect the positive battery cable, loosen the tension on the drive belt for the alternator, remove the electrical connections to the alt, remove the alt, and reverse the procedure. Tighten the drive belt tensioner to the required factory specs. Reconnect the battery cable.


Remove center hub cover maybe spring loaded Slide gear out Remove spanner nut Remove washers Wheel bearing should slide out Hub should slide off spindle


unplug electrical connectors. remove drive belt. remove alternator mounting bolts and remove alternator. installation is reverse.


This requires a special tool to remove and install the pulley. Most auto parts stores should have one in stock Best to remove the pulley with the pump removed from the engine compartment.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.